Electrolux WHGL6030CN Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Electrolux WHGL6030CN. Electrolux WHGL6030CN 28 сторінок.
Також для Electrolux WHGL6030CN: Посібник користувача (29 сторінок), Посібник з монтажу (12 сторінок), Посібник з монтажу (12 сторінок)
Друкувати сторінку
www.electrolux.com
6
4. CONTROLS
Button
L
T1
T2
T3
T4
T5
F
L T1 T2 T3 T4 T5 F
Basic function
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate
the lighting system in "courtesy light" mode. The lights
are lit at a reduced power of approximately 5W. This
function can be disabled by pressing the button once
again for 2 seconds or by pressing it briefly to switch
to normal lighting mode.
Turns the motor off from whatever speed it is set to.
Press and hold the button for 3 seconds with all the
loads turned off (Motor and Lights), to turn the Activated
Charcoal Filter alarm on/off.
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two. Button on.
Press and hold the button for approximately 2" to turn
the Delay function on and off, that is to say to turn the
appliance off after a 20 minute delay. Suitable to complete
elimination of residual odours. Can be activated from
the OFF position and from speeds 1, 2, 3. Cannot be
activated with Intensive speed On.
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a
timed period of 5 minutes. At the end of the 5 minutes
the appliance will automatically return to the speed
that was set before. If the appliance was turned off at
the time of activation, at the end of the 5 minutes the
system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm
indicator, shown by flashing of button T1. This procedure
can only be carried out with the motor off.
Indicator lights
Button off.
Lights off.
Button lit.
Lights on.
Button lit.
Courtesy light on.
Button lit.
Motor active.
Motor inactive.
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on.
Speed two on.
Buttons flashing
(T1+T2 or T3
Delay functionActive.
or T4).
Button on.
Button on.
Signals the Metal Grease
Filter saturation alarm, indi-
cating that it is necessary to
Button on
wash the filters. The alarm
is triggered after the Hood
has been in operation for
100 working hours.
When this is activated, it sig-
nals the Activated Charcoal
Filter saturation alarm, indi-
cating that the filter must be
changed; the Metal Grease
Button flashing
Filters must also be washed.
The Activated Charcoal Filter
saturation alarm comes into
operation after the Hood has
been working for 200 hours.