Bose 301 Series IV Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Bose 301 Series IV. Bose 301 Series IV 13 сторінок. Direct/reflecting speakers
Також для Bose 301 Series IV: Посібник користувача (12 сторінок), Посібник користувача (12 сторінок), Посібник з експлуатації (12 сторінок)

Check the connections

Check to be sure all connections are made positive to positive

(+ to +) and negative to

negative (- to -) (Figure 4) Make sure that no loose strands of wire touch across terminals

Bridged wires can short circuit and damage the amplifier Tighten any loose connections

before you plug in the receiver and turn it on

Back of RIGHT speaker

Back of receiver

Back of LEFT speaker

Figure 4

Completed connections

Test the speakers

To make sure your speakers operate correctly

Place the speakers less than 6 inches (15 cm) apart, facing each other

Turn on your receiver Set the receiver to MONO (monophonic), if that is an option on

your receiver

Make sure that all special effects (such as surround sound) are turned off

Set the balance control to normal (center position)

Play some deep bass passages of music through the speaker

The sound should seem to come from a point between the two speakers The bass should

be full and natural If it is not, one of the connections may be reversed, causing the speakers

to play out of phase (refer to "Make the connections" on page 6)

To correct the problem, make sure all the wires are connected positive to positive

(+ to +)

and negative to negative (- to -) Then repeat steps 1 through 5 above to re-test

the speakers