Bose ACOUSTIMASS PRO Посібник - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник для Спікери Bose ACOUSTIMASS PRO. Bose ACOUSTIMASS PRO 19 сторінок.
1. Parts that have special safety characteristics are identified by the
schematics or by special notes in the part lists. Use only replacement parts that
have critical characteristics recommended by the manufacturer.
2. Make leakage current or resistance measurements to determine that exposed
parts are acceptably insulated from the supply circuit before returning the unit
to the customer. Use the following checks to perform these measurements:
A. Leakage Current Hot Check-With the unit completely reassembled, plug
the AC line cord directly into a 120V AC outlet. (Do not use an isolation
transformer during this test.) Use a leakage current tester or a metering
system that complies with American National Standards Institute (ANSI)
C101.1 "Leakage Current for Appliances" and Underwriters Laboratories
(UL) 1492 (71). With the unit AC switch first in the ON position and then in
OFF position, measure from a known earth ground (metal water pipe,
conduit, etc.) to all exposed metal parts of the unit (antennas, handle bracket,
metal cabinet, screw-heads, metallic overlays, control shafts, etc.), especially
any exposed metal parts that offer an electrical return path to the chassis.
Any current measured must not exceed 0.5 milliamp. Reverse the unit's
power cord plug in the outlet and repeat test. ANY MEASUREMENTS NOT
WITHIN THE LIMITS SPECIFIED HEREIN INDICATE A POTENTIAL SHOCK
HAZARD THAT MUST BE ELIMINATED BEFORE RETURNING THE UNIT
TO THE CUSTOMER.
B. Insulation Resistance Test Cold Check-(1) Unplug the power supply and
connect a jumper wire between the two prongs of the plug. (2) Turn on the
power switch of the unit. (3) Measure the resistance with an ohmmeter be-
tween the jumpered AC plug and each exposed metallic cabinet part on the
unit. When the exposed metallic part has a return path to the chassis, the
reading should be between 1 and 5.2 Meg ohms. When there is no return
path to the chassis, the reading must be "infinite". If it is not within the limits
specified, there is the possibility of a shock hazard, and the unit must be
repaired and rechecked before it is returned to the customer.
CAUTION: THE BOSE
TEM CONTAINS NO USER SERVICEABLE PARTS. TO PREVENT WARRANTY INFRAC-
TIONS, REFER SERVICING TO WARRANTY SERVICE STATIONS OR FACTORY SER-
VICE.
SAFETY INFORMATION
®
®
ACOUSTIMASS
PROFESSIONAL POWERED SPEAKER SYS-
2
symbol on