Bose L1 Model I Посібник користувача - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Bose L1 Model I. Bose L1 Model I 32 сторінки. Troubleshooting
Також для Bose L1 Model I: Посібник з швидкого налаштування (2 сторінок), Усунення несправностей (2 сторінок)

Друкувати сторінку

ETUP

Product assembly

1. Place the L1 model I power stand on the floor.

Place it on a flat, dry, stable surface at the rearmost part of

the stage, handle facing forward, behind the performer.

WARNING: The completed unit

weighs about 60 lb (27 kg).

Moving the completely

assembled unit is not

recommended.

For placement guidelines, see

"Placing the product in the

right location for your perfor-

mance" on page 15.

2. Insert the bottom section of the

L1 model I Cylindrical Radiator

loudspeaker into the L1 model I

power stand. You should hear a soft

click when it is properly seated and

locked in place.

Note: Electrical connections

between the L1 model I

power stand and L1 model I

Cylindrical Radiator

loudspeaker are made

automatically as you

assemble the product.

3. Mount the top section of the L1 model I

Cylindrical Radiator

loudspeaker. Place one foot on

the L1 model I power stand to support your back. Insert

the bayonet on the top section into

the channel that runs along the back

of the bottom section. Lower the top

section until it is flush with the top of

the bottom section. You should hear

a soft click as the top section locks

in place.

4. Connect the R1 remote control to the L1 model

I power stand. Plug the R1 remote control cable into

either end of the remote. Plug the other end into the

Remote jack on the L1 model I power stand.

5. Place the R1 remote control within reach of

your performance position. This will allow you to

both hear your performance and to control it directly.

Note: If you power up the system without the R1 remote

control, it will function as if all the knobs on the R1 remote

control are at center position (12 o'clock).

6. Plug in the L1 model I power stand and turn it

on. Plug the female end of the power cord into the AC

Mains jack on the L1 model I power stand. Plug the

other end into an AC (mains) receptacle.

CAUTION: Bose recommends using a quality surge

suppressor on all electronic equipment. Voltage

variations and spikes can damage electronic

components in any system. A quality suppressor,

which can eliminate the vast majority of failures

attributed to surges, may be purchased at

electronics stores.

Your L1™ model I system is now set up

and ready for the addition of other

equipment.

• See "Using an effects processor" on page 25.