Connecting the Acoustimass
Figure 10
Acoustimass module con-
nection to media center
®
module to the media center
Connect the Acoustimass module to the media center with the audio input cable (Figure 10).
Note: Be sure that each connector is fully inserted into each jack.
1. Plug the small black multi-pin connector (flat side facing up) into the SPEAKER ZONES
jack labeled "1" on the back of the media center.
2. Insert the telephone-style RJ-45 connector on the other end of the audio input cable into
the AUDIO INPUT jack on the Acoustimass module. When properly connected, it should
lock in place.
Note: Refer to "Setting up a second listening zone" on page 25 for information on connecting
a second zone.
33V
DC POWER
1.1A
TV
SENSOR
IR
EMITTER
1
1
SERIAL
DATA
2
SPEAKER
ZONES
Audio input cable
CAUTION: Do not place strain on the audio input cable, especially on the connection to the
Acoustimass module. Placing excessive strain on the cable may cause damage to the cable
connection at the Acoustimass module. When disconnecting the cable from the Acoustimass
module, be sure to press the tab on the connector.
AM259777_02_V.pdf • April 23, 2002
System Installation Instructions
RECORD
TAPE
AUX
VCR
L
L
L
L
L
AM
FM
75
ANTENNA
R
R
R
R
R
OPTICAL
OPTICAL
DIGITAL
DIGITAL
DIGITAL
DIGITAL
DIGITAL
DIGITAL
INPUT
OUTPUT
AUDIO OUTPUTS
AUDIO INPUTS
Acoustimass module
connector panel
AUDIO
INPUT
L
C
R
Note: Press tab to release cable connector.
When fully inserted into the jack, the connector
locks in place.
TV
VIDEO INPUTS
COMPOSITE
S-VIDEO
COMPOSITE
S-VIDEO
VIDEO OUTPUTS
OUTPUTS TO
CUBE SPEAKERS
FRONT
SURROUND
POWER
100-120/200-240V AC
350W MAX.
L
R
50/60 Hz
13