Atlas Copco PHD 26 Інструкція з ремонту - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з ремонту для Дриль. Atlas Copco PHD 26. Atlas Copco PHD 26 8 сторінок.

Maintenance

General

It is recommended to regularly submit the tool to maintenance, or as soon as the hammer mechanism

gets weak, or when the carbon brushes switch off. When carrying out maintenance all parts of the

maintenance set must be exchanged. Use the respective maintenance set provided for each machine.

Cleaning

Clean all parts – with the exception of the electrical parts – with cold cleaning agent. Caution! No

cleaning agent should penetrate into the bearing. Clean the electrical parts with a dry brush.

Check for wear

Check the disassembled parts for wear (visual inspection) and replace worn parts.

Electrical tests

Before reassembling, perform an electrical test on all relevant parts (see chapter Electrical and

Mechanical Test Instructions).

Lubrication

Each time maintenance is performed, the machine is to be lubricates as stated in the lubrication plan.

After the machine is fully disassembled, completely remove the old grease and replace with new

grease. The grease must be applied to the machine as indicated in the lubrication plan.

Legend

A Cover generously

B Filling

Torques

Screws M 4

Screws M 5

Repair Instructions No. 162.11/95

PHD 26/ PH(D) 38/ PH 240 D/ PH 350 (D)

3 Nm

6 Nm

PAGE