Bose Wave radio Series III Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Bose Wave radio Series III. Bose Wave radio Series III 26 сторінок. Enabling standby low power mode
Також для Bose Wave radio Series III: Посібник із швидкого старту (2 сторінок), Посібник із швидкого старту (2 сторінок)
Друкувати сторінку
Setting Up
Setting up the remote control
Figure 4
Locating the safety lock
8
WARNING: Keep the remote control battery away from children. It may cause a fire or
chemical burn if mishandled. Do not recharge, disassemble, heat above 100˚C (212˚F), or
incinerate. Dispose of used battery promptly. Replace only with a battery of the correct type
and model number.
Your remote control may be one of two types (Figure 4A or 4B). Each is identified by the way
the battery compartment unlocks to install or replace the battery.
1. Place the remote control face down on a flat surface.
2. If your remote has a slot on the back (Figure 4A), follow step A. Otherwise, follow step B
and refer to Figure 4B:
A. Insert the tip of a ballpoint pen into the slot. Push to the side as shown and hold. Slide
the battery compartment open with your finger.
B. Using your finger, push the tab lock to the side as shown and hold. Slide the battery
compartment open.
A
B
Slot
Tab
+ Symbol
+ Symbol