Bose Acoustimass 6 Series III Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система Bose Acoustimass 6 Series III. Bose Acoustimass 6 Series III 18 сторінок. Home theater speaker sytem
Також для Bose Acoustimass 6 Series III: Посібник з швидкого налаштування (1 сторінок), Посібник користувача (44 сторінок), Посібник користувача (16 сторінок), Посібник користувача (25 сторінок), Посібник користувача (23 сторінок)

Setting Up

Connecting the Acoustimass

The 20-foot (6.1 m) system input cable connects the module to your surround receiver (see

Figure 6). The system input cable has a multi-pin connector on one end and several wire pairs

on the other. The wire pairs of the cable may be separated or "unzipped" as much as needed

to comfortably reach the surround receiver connections. Each wire pair is marked on the

cable jacket with RIGHT, LEFT, CENTER, RIGHT SURROUND or LEFT SURROUND to indi-

cate where each wire connects to the receiver.

CAUTION: Before making any connections turn off your receiver and unplug it from the AC

(mains) outlet. Not doing so may result in damage to your system.

CAUTION: Do not connect the powered Acoustimass module directly to your TV unless the

TV provides surround decoding circuitry and amplified outputs for all channels.

1. Insert the multi-pin connector on the system input cable into the input jack on the Acous-

timass module. Tighten the two thumbscrews to assure a secure connection.

2. Connect each wire pair on the other end of the system input cable to your surround

receiver. Carefully match the polarity of the connections (+ to + and – to –).

• Attach each marked wire (+) to the appropriate + terminal.

• Attach each plain wire (–) to the appropriate – terminal.

Note: The RCA plug of the system input cable comes with a cover installed. Remove this

cover for connection to the LFE/SUBWOOFER OUT jack. If your receiver has no LFE/SUB-

WOOFER OUT jack, leave the plug cover in place.

3. If applicable, connect the RCA plug on the system input cable to the LFE/SUBWOOFER

OUT jack on your surround receiver.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your

receiver.

module to the receiver