Bose ShowMatch SM10 Інструкція з використання та застосування - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з використання та застосування для Акустична система Bose ShowMatch SM10. Bose ShowMatch SM10 28 сторінок. Deltaq array loudspeakers
Також для Bose ShowMatch SM10: Інструкції з монтажу та безпеки (16 сторінок)

Друкувати сторінку

Bose ShowMatch SM10 Інструкція з використання та застосування

SHOWMATCH TOUR RACK CONNECTION

Operation and configuration of the ShowMatch Tour Rack is accomplished using the ArmoníaPlus software, available for

download at www. PowerSoft-audio.com. When connecting to the ShowMatch Tour Rack use the following steps:

1. Make sure that the ShowMatch Tour Rack is powered on and an active Ethernet connection is established between

the PC and the rack.

2. Open the ArmoníaPlus software and open the Bose ShowMatch Rack configuration file. The ShowMatch rack ships

preconfigured for operation.

3. You will need to associate the amplifier in the ShowMatch Tour Rack with the virtual devices in the configuration file.

To accomplish this first select "Match" from the workflow selections along the bottom edge of the screen.

Make sure that the PC is not running a fixed IP address. All devices in the ShowMatch Tour Rack are configured for DHCP operation

and will automatically default to an address in the range of (169.254.xxx.yyy) when no DHCP server is present. The PC will do the

same, allowing you to communicate with the amplifiers within the ShowMatch Tour Rack. For detailed connection and configuration

instructions for the PowerSoft X4 Dante amplifier see the PowerSoft X Series User Guide.

4. Amplifiers will be automatically detected and displayed on the right-hand side of the screen. If amplifiers are

not present, check your network settings.

Select the top-most amplifier within the virtual rack. It will be selected and display the number 1. Then select

the link/pair button on the front panel of the corresponding amp within the rack.

The two devices are now logically linked; a successful link is indicated when the paired devices are green.

Repeat this process for remaining amplifiers. Once you have completed this for all amplifiers, the system is ready for

operation.

5. The ShowMatch Tour Rack is preconfigured to operate a system comprised of six ShowMatch modules per side with

four subwoofers per side.

The system is muted by default to prevent damage to system components during set up.

PRO.BOSE.COM