English
Español
Problem
With a Plasma
TV turned on,
the LIFESTYLE
®
remote
behaves erratically
System turns on by itself,
or behaves erratically
Radio does not work
The disc does not play
FM sound is distorted
FM sound is noisy
in surround mode
Sound is distorted
No sound from
TV, CD/DVD, VCR,
or AUX
No video on screen,
though the TV audio is
right
LIFESTYLE
®
remote
does not control
your TV, VCR,
cable/satellite box,
or other external
component
Your TV turns
on and off unexpectedly
Français
What to do
• Momentarily disconnect the video cable (composite, S-video or component) and see if
remote performance improves.
• If performance improves, the problem may be remedied by obtaining "ferrite chokes" and
placing them on the cable to draw away the interference. To purchase the chokes, contact
Bose Customer Service for assistance.
• Change the house code setting to prevent signals from conflicting with another nearby
LIFESTYLE
®
system. (See "Changing remote control switch settings" on page 38).
• Make sure antennas are connected properly.
• Move AM antenna at least 20 inches (50 cm) from the media center.
• Adjust antenna position to improve reception.
• Make sure the AM antenna is in an upright position.
• Move antennas farther from media center, TV, or other electronic equipment.
• Select another station. You may be in an area of weak signal coverage for some stations.
• After pressing the CD/DVD button, wait a few seconds before pressing Play.
• Make sure the disc is properly inserted (label side up).
• Eject the disc and try loading it again.
• The CD may be dirty. See "Cleaning discs" on page 41.
• Try another CD. The CD may be defective or not compatible. See "Clarifying some basics"
on page 5.
• Adjust antenna position to reduce interference.
• Weak FM stations will produce static in the surround speakers. Select the 2-speaker mode
in the Settings menu to minimize noise. See "Tuner setting options (FM or AM radio)" on
page 35.
• Make sure speaker cables are not damaged and the connections are secure.
• Reduce the output level from any external components connected to the media center.
• Check the connections.
• Make sure that component is turned on.
• Refer to the component owner's manual.
• Check the TV Video input selection. Make sure it is correct for the video source.
• Make sure correct codes are set. See "Setting the remote to control each component" on
page 19.
• Make sure that the front of the media center is not obstructed. The IR emitter that sends
commands to your external components is below the disc tray.
• If you still cannot control your external components successfully, you may need to connect
the external IR emitter, included with your system, to the IR EMITTER jack on the rear
panel of the media center. See "Connecting the optional IR emitter cable" in your
Installation Guide.
• Reposition the TV on/off sensor on the back of your TV. Or check the SCART connector if
you use one.
• Verify that the TV on/off sensor is working properly by choosing
Video in the System menu.
R
EFERENCE
under
TV Power Status
43
Друкувати сторінку