Bose AM-3P II Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Стереосистема Bose AM-3P II. Bose AM-3P II 43 сторінки.

The two primary windings of the transformer are wired in series for 230V operation, and in

parallel for 115V operation, depending on the position of the customer accessible voltage

select switch. If the system is accidentally energized at 230V with the switch in the 115V

position, the replaceable fuse (F1 located on the Main PCB assembly), will open the circuit

within two minutes. This will be the only damage to the system.

A non-serviceable thermal fuse is located inside the transformer to limit the maximum

temperature to 145 °C under abnormal conditions. However, in most cases the external fuse

(F1) should fail before the internal transformer thermal fuse. The thermal fuse can be checked

by measuring the continuity between pins 1 and 4 (black and white wire) of the primary

connector. This connector is located on the Main PCB.

2. Differential Input Stage

Audio input applied at the phono jack (J8) connects directly to the right (left) differential amplifier

buffer. This stage accomplishes several functions:

• Provides rejection of common-mode interference (such as hum) that might be picked up

by the long audio cable between the AM-3P II and Lifestyle

• Provides input overload and ESD protection through diodes (D101-D104)

• Removes radio frequency interference through C103, C125, C127

• Provides DC blockage by C101,102

• Provides a 6 dB gain through op-amp U101.

3. Compressor/Treble Stage

U102 (pins 1, 2, 3) with potentiometer VR2 at the center position, operates as a conventional

inverting operational amplifier stage with a gain of 6 dB. However, when voltage overload is

present at the speaker outputs, transistor array U1 (pins 1, 2, 3) receives a turn-on signal from

the compressor detect stage. Under this condition, the transistor acts as a variable resistor to

ground, and with R107, forms a resistor divider network that attenuates the audio signal. The

amount of attenuation and timing action is carefully controlled by the compressor detect stage

(to be discussed later).

Potentiometer VR2 adjusts the amount of treble boost or cut. In the full counterclockwise

position, the wiper (pin 4) shorts to pin 1. The maximum boost and cut frequency response

graph is shown in Figure 2 on page 5.

music center