Bose Companion 3 Series II Посібник користувача - Сторінка 7

Друкувати сторінку

Bose Companion 3 Series II Посібник користувача

Selecting a location for your Lifestyle

Figure 2

Required clearance

between the ampliﬁer and

any material or surface.

Figure 3

Horizontal surface mounting

Figure 4

Wall mounting

AM262840_00_V.pdf

Select a location for your Lifestyle

CAUTION: DO NOT mount the ampliﬁer on surfaces that are not sturdy enough, or that have hazards con-

cealed behind them, such as electrical wiring or plumbing. The ampliﬁer must be placed indoors. It is nei-

ther designed nor tested for use outdoors or on boats.

Although the ampliﬁer does not need to be situated close to either your Lifestyle

speakers, consider the following guidelines when selecting a location for your ampliﬁer:

• Locate the ampliﬁer indoors and within 8 feet (2.5 m) of a power outlet.

• Make sure that the ampliﬁer is located within the reach of the supplied 30-foot audio input cable.

• Place the ampliﬁer in an area where the maximum ambient temperature is less than 104 F (45 C).

• For optimum performance, place the ampliﬁer in a well-ventilated area.

• DO NOT PLACE THE AMPLIFIER IN A COMPLETELY ENCLOSED AREA – If the ampliﬁer is installed on a

shelf, or in a bookcase, or inside an entertainment center, maintain 2.0 inches (5.0 cm) minimum clearance

(Figure 2) on all sides of the ampliﬁer with an open area of 3.0 inches (7.5 cm) minimum immediately above

it to allow for air ﬂow. If adequate ventilation is not provided, the ampliﬁer will automatically protect itself

by reducing its volume level in order to limit its temperature.

• DO NOT place the ampliﬁer on any heat-sensitive surface, such as the ﬁnished surface of ﬁne furniture.

Like all electrical equipment, it generates some heat.

• DO NOT use the ampliﬁer in a damp location. It is important to prevent moisture from getting into the unit.

3.0 in.

(7.5 cm)

2.0 in.

(5.0 cm)

2.0 in.

(5.0 cm)

• When mounting the ampliﬁer on a horizontal surface like a ﬂoor or shelf (Figure 3), the ampliﬁer's rubber

feet provide stability and prevent scratches.

• To mount the ampliﬁer on a wall (Figure 4), remove the rubber feet and use the existing guide holes in the

ampliﬁer's enclosure. See Figure 5 on page 6 for recommended mounting hardware.

January 4, 2002

Setting Up Your Lifestyle

stereo ampliﬁer

stereo ampliﬁer and mount it according to the following guidelines.

2.0 in.

(5.0 cm)

2.0 in.

(5.0 cm)

Stereo Amplifier

system or the accessory