Bose L1 Model II Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Стереосистема Bose L1 Model II. Bose L1 Model II 15 сторінок. Portable line array systems
Також для Bose L1 Model II: Посібник користувача (32 сторінок), Посібник користувача (32 сторінок), Посібник користувача (28 сторінок), Технічний паспорт (8 сторінок), Технічний паспорт (8 сторінок), Посібник із застосування (13 сторінок)

Друкувати сторінку

English

Dansk

Deutsch

Español

Dansk

Setting the analog input level

Using a T1 ToneMatch

User scenarios

Figure 11

Single L1 model II system

with keyboard

Français

Deutsch

Italiano

Nederlands

Español

When connecting an audio source to the Analog Input, follow these steps to adjust the input

Trim control.

1. Set the Trim control on the power stand to the 0 (zero) position.

2. Connect the audio source to the Analog Input.

3. Adjust the volume of the audio source to the desired level.

4. While playing the source, increase the Trim level until the Signal/Clip indicator glows

green or yellow.

5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green

or yellow.

audio engine and an analog input source

The L1

model II system can operate with both a T1 ToneMatch

log audio source connected to the power stand. However, keep in mind that the volume level

of the audio engine and the analog audio source is adjusted independently.

• The power stand Trim control only affects the volume level of the analog audio source con-

nected to the Analog Input. Therefore, the Signal/Clip indicator indicates the status only

of the analog input signal.

• The T1 ToneMatch audio engine has a Trim control and signal/clip indicator for each input,

a Volume control for each output channel, and a Master volume control that adjusts the

level of the ToneMatch output sent to the power stand. These controls have no effect on

the signal fed to the Analog Input.

There are many ways to set up and use this system with and without the T1 ToneMatch audio

engine. The following pages show examples of some typical user scenarios. When using the

T1 ToneMatch audio engine, refer to its owner's guide for more information on setup and

operation.

Single musician

A solo musician might play a single instrument through the L1 model II system (Figure 11).

A solo musician also might play an instrument and use a microphone for vocals (Figure 12 on

page 16).

Français

Svenska

Italiano

PERATING

Nederlands

Svenska

NFORMATION

audio engine and an ana-