Bose Acoustic Wave Series II Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа Bose Acoustic Wave Series II. Bose Acoustic Wave Series II 20 сторінок. 4x4 mic/line input/output card
Також для Bose Acoustic Wave Series II: Посібник користувача (20 сторінок), Встановлення (3 сторінок), Посібник (2 сторінок), Посібник (46 сторінок)
Друкувати сторінку
Unpack the carton
Carefully unpack the carton. Do not attempt to use the Wave
damaged. Instead, repack the carton and notify Bose
ately.
It is best to place the radio across the room from where you will be listening. Place the radio on
a table or other flat surface. Do not put it on a metal surface or table that could interfere with
AM reception. If you will use the radio with your television or VCR, do not place it on top of the
television. It may interfere with the picture quality.
Locate the power cord, AA batteries, remote control, and lithium battery.
Wave
radio
Power cord
Install the batteries
The Wave radio's three AA batteries maintain the memory and backup alarm system for up to a
week during a power failure, or while the radio is unplugged. Operating without batteries leaves
the memory unprotected, but will not harm the radio. Use AA batteries (IEC-R6 in Europe),
available at many retail stores.
Note: The batteries will not power the radio or
light the display.
1. Carefully turn your radio upside down (avoid
scratching its top).
2. Locate the battery compartment on the
bottom (see Figure 2).
3. Press the arrow on the cover to slide the
compartment open.
4. Place the batteries inside, matching the +
and – symbols with the symbols inside the
compartment.
5. Slide the cover back and turn the radio right
side up.
AM189930_01_V.pdf
®
radio if any part appears
®
or your authorized Bose dealer immedi-
3 AA batteries
Remote control
Lithium
battery
+
–
OUT
VARIABLE
IN
AUX
L
R
January 4, 2002
Figure 1
What comes with your radio.
• Wave radio
• Power cord
• Remote control
• Lithium battery
• AA batteries
Figure 2
+
Installing the batteries.
Setting Up
5