Bose 2060 Посібник інсталятора - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник інсталятора для Підсилювач Bose 2060. Bose 2060 40 сторінок. Commercial power amplifiers

8. AC power sequence connector (cont.)

SEQUENCE

SND RCV

SEQUENCE

SND RCV

SEQUENCE

SND RCV

To remotely begin the sequencing function, close the circuit and supply the DC voltage to

the RCV receive pin on the first amplifier. The subsequent amplifiers should turn on at 0.5

second intervals.

Note: The front panel power switch should be in the STANDBY position on all of the

amplifiers in this group.

When the DC voltage is interrupted, the amplifiers will then turn off. If there are signal

processing and input source devices in the system, they should be turned on before the

amplifiers are sequenced on, and these same devices should be powered down after the

amplifiers are sequenced off. This will avoid large transient thumps being passed to the

loudspeakers attached to the system.

When using multiple amplifiers that utilize the SEQUENCE feature of the Bose

you would like to power them on, but remote operation is not required, you do not need the

DC Voltage to activate the SEQUENCE function. Simply connect the SND send terminal of

the first amplifier to the RCV receive terminal of the next amplifier and so on (see Figure 9).

The front panel power switch of the first amplifier will activate the SEQUENCE function

when switched to the ON position. All other front panel power switches should be in the

STANDBY position for the SEQUENCE function to operate properly. Again, if the amplifiers

are mounted together in a rack where the chassis grounds are connected together through

common connection via the metal rack rail or by a common AC ground, no other connec-

tions should be required. If this is not the case, simply connect all of the chassis ground

terminals together.

SEQUENCE

SND RCV

SEQUENCE

SND RCV

SEQUENCE

SND RCV

AM259107_00_V.pdf

12-15 VDC Supply

November 19, 2001

4.0 Operation

Figure 8

Connect all the chassis ground

terminals together

2150, and

Figure 9

Ground test procedure