Bose Acoustimass 5 Series III Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Bose Acoustimass 5 Series III. Bose Acoustimass 5 Series III 16 сторінок. Bose lifestyle amplifier user's guide am262840
Також для Bose Acoustimass 5 Series III: Посібник користувача (29 сторінок), Посібник користувача (22 сторінок)
Друкувати сторінку
- 1. Selecting the Locations for Your Acoustimass System Components
- 2. Examining the Cables and Connections
- 3. Connecting the Cube Arrays to the Acoustimass Module
- 4. Connecting the Acoustimass 5 Series III System to Your Receiver
- 5. Positioning Your Speaker System to Get the Best Sound
- 6. Technical Information
Maintaining your speaker system
Troubleshooting
Problem
One of the cube arrays
does not play
The Acoustimass 5 speaker
system does not play or
sounds distorted
AM196451_05_V.pdf
Maintaining Your Acoustimass
The cabinets of your Acoustimass 5 Series III speaker system may be cleaned with a soft
damp cloth. Do not use any sprays near the system or allow liquids to spill into any open-
ings. Also, do not use any solvents, chemicals, or cleaning solutions containing alcohol,
ammonia, or abrasives.
The grille assemblies on the cube arrays may be carefully vacuumed if necessary. Please
note that the drivers are located directly behind the grille cloth, and are easily damaged if
reasonable care is not taken.
What to do
• Turn off the receiver or amplifier. Check the wiring that connects the cube array to the
Acoustimass module, and the wiring that connects the module to the receiver or amplifier.
If no problem is found, disconnect the speaker wires at the back of the receiver. Recon-
nect only the wire from the channel in question to the opposite channel at the receiver.
Turn the balance control completely to that channel, and turn the power on. If the cube
array now works properly, the problem is in the receiver or amplifier.
• Do not connect the other cube array to the defective channel. It could damage your
speaker system.
• Turn off the receiver or amplifier and disconnect the Acoustimass 5 speaker system.
Reconnect the system to another receiver known to be working properly. If the
Acoustimass 5 system now works properly, the problem is not in the speaker system.
• If this is the case, you should check all user accessible fuses on your receiver or amplifier
(see the appropriate owner's guide for help). If the fuses blow again, have the unit checked
by qualified personnel.
• If trouble persists in your Acoustimass 5 speaker system, contact your authorized Bose
dealer, who will verify any defects and arrange for service by an authorized agency or by
the Bose factory. Bose will make every effort to remedy any problem within the terms of
the warranty at minimum inconvenience to you.
October 23, 2001
®
5 Series III Speaker System
®
11