Bose M277296_01_PAS_UKEvo Посібник користувача - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Bose M277296_01_PAS_UKEvo. Bose M277296_01_PAS_UKEvo 28 сторінок.

Operating Instructions

Figure 9

Using a parallel effects

connection

Using parallel effects connection with the PS1 power stand

Note: Connecting an effects unit in parallel requires one ¼-inch unbalanced (instrument) cable,

one mono ¼-inch phone (M) to dual mono ¼-inch phone (F) "Y" cable adaptor, and one TRS split

"insert" cable (with a ¼-inch TRS connector on one side and two mono ¼-inch phone connec-

tors on the other).

1. Insert the TRS plug into the Channel 1 Insert jack on the PS1 power stand.

2. Connect both ¼-inch plugs from the "insert" cable into both receptacles on the "Y" cable

adaptor.

3. Connect the plug of the "Y" cable adapter into the input of the effects processor.

4. Connect the ¼-inch unbalanced (instrument) cable from the output of the effects

processor to Channel 3 Line IN of the PS1 power stand.

5. Set the effects level of the processor to full and turn the mix level of the effects processor

to full "wet".

6. Adjust the Channel 3 Level control of the PS1 power stand for the desirable effects mix.

1/4-inch Instrument Cable

Connect to

Channel 1 Insert

Channel 3 Line IN

PS1 power stand

TRS split "insert" cable

Connect to Effects

Unit OUTPUT

Mono 1/4-inch Phone (M) to

dual mono 1/4-inch Phone (F)

"Y" cable adaptor

Connect to Effect Unit INPUT

Digital Effects Unit