Drolo Strands Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Музична педаль Drolo Strands. Drolo Strands 4 сторінки.

EXP input:

An expression pedal or control voltage (CV) source can be used to

alter either the direction or the fidelity parameter.

When an external expression source is connected to the pedal, the

direction or fidelity knob sets the maximum range of the expression

input. Most commercially available expression pedals that use a

standard TRS plug should work with Strands. However, for optimum

results it's best to use one with a resistance value of 10k or higher.

DO NOT USE A TS (MONO) PLUG OR CABLE. This will

short out the voltage regulators in the pedal, and may cause

permanent damage. You must use a 1/4-inch TRS (stereo) cable.

The standard TRS connections are:

- tip: controlling pin

- ring: 3.3V supply voltage

- sleeve : ground

You can use a control voltage for expression instead of a resistance-

based controller, if you're confident with electronics. However, make

sure to consider the required connections, and don't exceed 3.3V.

If you have any questions about connecting something to the

expression input, please send me an email and I'll be able to help.

Power Supply:

Strands requires a 9V DC, 100mA center-negative power supply.This

is the most commonly used type of guitar pedal power supply, but it's

still important to make sure the voltage (9V DC) and polarity (center-

negative) are correct, to avoid damaging the pedal.

NOTE: DO NOT RUN THE PEDAL AT HIGHER VOLTAGES.

Because this pedal uses a digital processor that operates at high

frequencies, you may hear additional noise if you use it on the same

power supply as other pedals (daisy chained). This can happen even

when the pedal is bypassed, as the noise may bleed through the

power supply into other pedals.

Noise like this is common for pedals with digital processors, and the

best way to avoid it is by using an isolated power supply.

Specs:

Input Impedance: 1MΩ

Output Impedance : <1kΩ

Current : 100mA

Dimensions : 127mm x 95mm x 56mm

Thanks, and enjoy!

https://www.drolofx.com