3M Peltor LiteCom MT53H7B4600-NA Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Гарнітури 3M Peltor LiteCom MT53H7B4600-NA. 3M Peltor LiteCom MT53H7B4600-NA 15 сторінок. The sound solution
Також для 3M Peltor LiteCom MT53H7B4600-NA: Посібник (18 сторінок)
Друкувати сторінку
EN
use time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal transceiver operation is 5%
transmission time, 5% reception time and 90% stand-by time.
6.3. IC Warning
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions:
(1)This device may not cause interference and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that, the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
7. CAUTION
When set to full gain the earphones can produce an equivalent sound level of up to 87dB(A). This is considered safe for daily
8-hours use, as long as the time spent in receiving mode does not exceed 2.5 hours. If the time spent listening to the earphones
exceeds 2.5 hours per day the gain setting must be reduced below maximum. One step below maximum gain produces an equi-
valent sound level of 82 dB(A), considered safe even if used in the listen mode, in noise, for a full 8-hours day.
If after wearing this device, tinnitus (ringing or buzzing in the ears) is heard, or your hearing seems muffled or dulled, or for any
other reason you suspect a hearing problem, the volume levels should be reduced and the fit, condition, and adequacy of this
device should be checked for the noise in which it is being worn. If the condition persists see an audiologist or physician for a
professional review.
8. SPARE PARTS/ACCESSORIES
3M™ Peltor™ HY79 Hygiene kit
Replaceable hygiene kit consisting of two attenuation cushions, two foam rings and two snap-in ear cushions. Replace at least
twice a year to ensure constant attenuation, hygiene and comfort.
3M™ Peltor™ HY100A Single-use protectors
A single-use protector that is easy to fit to the ear cushions. Pack of 100 pairs.
3M™ Peltor™ HYM1000 Microphone protector
Moisture-resistant and wind-resistant hygienic tape that protects the speech microphone and extends its life at the same time.
Pack of 16 feet (5 meters) is sufficient for around 50 replacements.
3M™ Peltor™ M995 Wind shield for electret microphone
Effective protection from wind noise for electret microphone that also protects it and extends its life. One protector per pack.
3M™ Peltor™ACK053 Rechargeable battery
NiMH rechargeable battery that can replace two AA type 1.5 V standard batteries.
3M™ Peltor™ FR08 Power supply
Power supply for FR09/ACK053.
3M™ Peltor™ FR09 Battery charger
Charger for ACK053
3M™ Peltor™ 1180 SV Battery cover
3M™ Peltor™ MT53N-12 Electret microphone
Supplied as standard with product.
Important Notice - Warning
These hearing protectors help reduce exposure to hazardous noise and other loud sounds. Misuse or failure to wear hearing
protectors at all times that you are exposed to noise may result in hearing loss or injury. For proper use, see supervisor, Fitting
Instructions, or call 3M Technical Service (in U.S.A. call 1-800-243-4630. In Canada, call 1-800-267-4414).
9