Dromida kodo hd Посібник користувача
Переглянути онлайн або завантажити pdf Посібник користувача для Дрони Dromida kodo hd. Dromida kodo hd 4 сторінки.
Друкувати сторінку
READ THESE
READ THESE
INSTRUCTIONS
INSTRUCTIONS
BEFORE FLYING !
BEFORE
™
KODO
Drone
USB
Charger
BC
CONTROLLER SETUP
Rudder
Photo
Mode 1/ Mode 2
Switch
Trim
Button
Throttle/Rudder
Throttle
ON/OFF Elevator
Stick
Trim
NOTE: For Mode 1 operation, slide the mode switch to the MD1 position
and flip the controller so the throttle is on the right side.
CHARGING the FLIGHT BATTERY
Plug charger into USB port or AC adapter (DIDP1125 not included)
as shown and connect the battery. The red LED will flash slowly
while the battery is charging. The LED will be steady when the
battery is fully charged.
• NEVER leave the battery unattended while charging.
• DO NOT allow the USB port to power down while the charger
is connected to the battery.
• ALWAYS unplug the charger from the USB port and the
battery when charging is complete.
• The battery connector will only fit in one way.
FLYING !
Blade Guards
Spare Blades
(2 black, 2 yellow)
Video
Aileron
Button
Trim
LED
Remove the screw on
the battery compartment
Aileron/Elevator
cover. Take the cover off
Trim
Stick
and insert 2 AAA batteries.
Replace cover securing
with the screw.
LINKING
Your KODO comes with a Power-On failsafe. This is designed to
ensure that the motors will not start until the KODO has detected
the controller.
The Kodo's motors are now armed and the quad is ready to fl y. The
red LED on the Kodo HD will become steady.
AAA Batteries
2G Memory Card
SENSITIVITY ADJUSTMENT
Push down on the left stick to
Lowest (Default)
• Do not mix old and new batteries
• Do not mix alkaline, standard, or
rechargeable batteries.
1. Turn on the controller with the throttle
at its lowest position.
2. Connect the battery to the Kodo HD
and place it on a level surface. Listen
for two beeps. The red LED at the
back of the quadcopter will start
fl ashing slowly.
3. Move the throttle to its highest position. Listen for a beep
4. Move the throttle back to its lowest position. Listen for three
beeps.
™
Controller
USB Card
Reader
change the sensitivity
of the controls.
x2
Moderate
x3
Maximum