Elegant Union Group G-600 Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для гриль Elegant Union Group G-600. Elegant Union Group G-600 13 сторінок. Portable
Друкувати сторінкуNever check for leaks with a naked flame, always use a soapy water solution
DANGER
To prevent fire or explosion hazard when testing for a leak:
1.
Always perform the leak test before lighting the grill and each time the cylinder is connected for use.
2.
Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3.
Conduct the leak test outdoors in a well-ventilated area.
4.
Do not use matches, lighters or a flame to check for leaks.
5.
Do not use grill until all leaks have been stopped. If you are unable to stop a leak, disconnect the propane
supply, call for gas appliance service or your local propane gas supplier.
1.
Make two to three oz. of leak solution by mixing one part liquid dishwashing soap with three parts water.
2.
Make sure control knob is in the "OFF" position.
3.
Spray some solution on the regulator connection.
4.
Inspect the solution at the connections for bubbles. If no bubbles appear, the connection is secure.
5.
If bubbles appear, you have a leak. Go to step 6.
6.
Disconnect the cylinder and reconnect. Make sure the connection is secured.
7.
Retest with solution after fixing the fault.
8.
Turn OFF the gas at the cylinder after testing.
9.
If leakage is detected and cannot be rectified, do NOT attempt to cure leakage but consult your gas dealer. .
DANGER:
Failure to open lid while igniting the grill's burners or not waiting five minutes to allow gas to
clear if the grill does not light, may result in an explosion, which could cause serious bodily injury or death.
WARNING:
To prevent possible bodily injury, never stand with your head directly over the grill when
preparing to light the main burners.
Lighting Instruction:
1.
Open lid while lighting burners.
WARNING:
Attempting to light the burner with the lid closed may cause an explosion. Make sure there are no
obstructions of airflow to the gas unit. Spiders and insects can nest and clog the burner/venturi tube at the
orifice. A clogged burner tube can lead to a fire beneath the appliance.
2.
The valve must be in the "OFF" position.
3.
Turn gas supply "ON" by connecting propane cylinder to regulator
inlet fitting.
4.
Push in control knob completely (3 to 4 seconds) and rotate slowly
about 1/4 turn counter clockwise until a click is heard. The burner should
light. Observe the burner flame and make sure all burner ports are lighted.
A blue/yellow flame of 1-2 inches should appear from the burner.
5.
If the burner does not light, turn the control knob to "OFF" position immediately.
Wait 5 minutes and repeat the lighting procedure.
6.
Adjust valve knob to desired cooking temperature.
Using the Lighting Stick to Light the Burners
1.
Insert a match into the end of the lighting stick and light it.
2.
Once lit, place the flame through the cooking grid slots to reach the burner ports. (see diagram to right).
BEFORE USE CHECK FOR LEAKS
CHECK FOR LEAKS
LIGHTING YOUR GRILL
10
1). Push in for 3 to 4 seconds,
2). Turn counterclockwise to "on",
3). Turn clockwise to "off".