Elegoo MARS 4 Series Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для 3D-принтери Elegoo MARS 4 Series. Elegoo MARS 4 Series 20 сторінок.
Також для Elegoo MARS 4 Series: Посібник користувача (20 сторінок)
Друкувати сторінку
Software Installation and Setup
3.3 Resin Parameter
(See Picture 14)
Resin Density:
1.1g/ml
Resin Cost:
You can input the real price of the resin you purchased, and the slicing software can
calculate the resin costs for each model you print.
3.4 Parameters
(See Picture 14)
Layer Height:
The thickness of each printed layer, the recommended height is 0.05mm, but you
can set it from 0.01-0.2mm. The higher thickness you set, the longer time it will take for exposure
of each layer.
Bottom Layer
Count:The setting number of initial printing layers. If the number of bottom layers
is n, the exposure time of the first n layers is the exposure time of the bottom layer, the default
setting is 2.
Exposure Time:
The exposure time for normal printing layers. The default exposure time is 2.5
seconds, and the thicker the printing layer setting is, the longer time it will take.
Transition Layers:
The number of transition layers after the bottom layer to make it stickier
between layers. Except for the exposure time, other parameters of the transition layer are the
same as the normal layer.
Bottom Exposure Time:
layer exposure time can help to increase the stickiness between the printing model and the build
platform; the default setting is 32 seconds. The longer the setting time, the stickier the bottom
layer will be on the build platform.
Wait After Lift:
After printing platform is lifted, the time difference between the printing platform
starts to stationary and starts to return, the default setting is 0 seconds.
Wait Before Cure:
After the build platform moves to the printing surface, the time difference
between the build platform starting to stationary and starting to exposure, the default setting is
0.5 seconds.
Wait After Cure:
The time difference between the end of the exposure and the start of the build
platform to leave the printing surface, the default setting is 0 seconds.
The setting of bottom layer exposure time. Properly increasing the bottom