DropEffect XG Hotend Інструкція з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Інструкція з монтажу для 3D-принтери DropEffect XG Hotend. DropEffect XG Hotend 12 сторінок.

Step 1

Hot - tightening is the last mechanical step before XG Hotend is ready!

It is essential for the sealing of the nozzle and heatbreak to ensure that

molten filaments do not leak out of the hotend during use.

Step 2

Using the printer's control software (or LCD screen) to set the hotend's

temperature to 285°C. Wait one minute after its temperature reaches

285°C to equalize the temperature of all components.

Step 3

Gently tighten the nozzle while fixing the heatblock with a

wrench, and tighten the nozzle . This will keep the nozzle close

to the heatbreak and ensure that the hotend does not leak.

Step 4

The tightening torque of the hot nozzle is about 2.5NM, which is

about the pressure applied by one finger on the small wrench.