247Security mDVR306 Короткий посібник - Сторінка 4
Переглянути онлайн або завантажити pdf Короткий посібник для ВІДЕОРЕЄСТРАТОР 247Security mDVR306. 247Security mDVR306 14 сторінок.
Друкувати сторінкуCAMERA CABLES
Camera Cables (available in lengths of 15, 35 or 50 feet) use the STP (shielded twisted pair) cable standard. The
Camera Cables are connected using molded 2x3 Molex interfaces that are keyed to prevent improper mating. Each
connector uses a clip to snap securely to each camera and to the inputs on your DVR. Typical configurations are
such that the passenger cameras connect to inputs 1 and 2; and, if available, door, exterior, or driver cameras
connect to inputs 3 and 4. After the installation, all Camera Cables should be concealed and holes filled with
grommets to protect the equipment from vandalism.
EVENT MARKER
The Event Marker is used for the driver to indicate a critical event during recording, which the DVR will interpret as a
priority video for later review. When the driver presses the event marker button, the DVR will mark all video feeds
from 150 seconds prior to and after the button press. These priority event videos can be retrieved by the technician,
using our USB memory stick, to be viewed on a computer with the DVRViewer application installed.
The Event Marker module has one button, to signal an event, and 3 color lights to indicate three DVR states: green
for POWER; amber for hard drive RECORDING; and red for VIDEO LOST when a camera signal has been lost.
POWER CABLE
A three-wire, 12-feet-long Power Cable is used for connecting the DVR directly to the battery power in the vehicle's
electrical box. The cable uses a large molded 2x2 Molex connector that is keyed, thereby connecting to the DVR in
only one orientation. The cable's three wires are described in the following table:
POWER CABLE
DC IN (Red)
GND (Black)
IGN. ON/OFF (White)
Two screws (#4 thread, 3/8" long) are included to securely fasten the Power Cable to the DVR. Securing the Power
Cable to the DVR prevents occupants from deactivating the system by disconnecting the Power Cable. NOTE: MAKE
SURE TO FUSE BOTH THE RED AND WHITE POWER LINES WITH A 7.5A FUSE (NOT INCLUDED)
SENSOR & ALARM CABLE (DIGITAL I/O)
The Digital I/O Cable is used for connecting the DVR to the vehicle's pertinent electrical functions, such as the turn
signals, brake pedal, and the stop-arm. The cable is 15 feet long and connects to the DVR using a molded 2x5
Molex connector, and to the vehicle's equipment using 4 twisted pairs of wires. Using the Digital I/O Cable is an
optional function at your discretion.
247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
Constant LIVE Power Source (battery side of solenoid, direct current)
Ignition-switched Power (live only if ignition is turned to ON/ ACC)
Digital Input #
Wire Color
DI 1
Brown
DI 2
Green+White
DI 3
Green
DI 4
Orange+White
DI 5
Orange
mDVR306 Installation
BUS ELECTRICAL PANEL
Ground in bus electrical panel
Function
TEXT OVERLAY – AMBER
TEXT OVERLAY – STOP-ARM
TEXT OVERLAY – BRAKES
TEXT OVERLAY – LEFT SIGNAL
TEXT OVERLAY – RIGHT SIGNAL
3
QUICK GUIDE