ankmax UC4M2 Короткий посібник - Сторінка 16

Переглянути онлайн або завантажити pdf Короткий посібник для Корпус ankmax UC4M2. ankmax UC4M2 17 сторінок. Usb 4 enclosure

9. Important Notes

 Do not directly remove the device being read and written.

 Before you disconnect the device from the computer, be sure to exit it safely, otherwise, there is a risk

of data loss.

When you turn off the computer, hibernate the computer, eject the device, or disconnect the device,



the device will automatically go to sleep; access the hard disk again or reconnect, the device will cancel

the sleep mode.

If your computer doesn't recognize the SSD enclosure, no drive letter appears? Please follow the steps

below to confirm:

Confirm whether to install a supported NVMe M.2 SSD. For details, please refer to the SSD compatibility list on the



official website.

For the new SSD, you need to enter the disk management and initialize the SSD before it can be detected and used



normally.

If the USB4 device is not recognized under Windows PC, please visit your PC manufacturer website and update your



Windows PC's Thunderbolt firmware and drivers to the latest version.

If the device indicator is not on, please confirm whether the SSD is installed in place, and try to reinstall the SSD



again.

If the device indicator is still not on, the SSD may be faulty, please try to replace the SSD for testing.



Detailed instructions under Mac devices:

https://www.ankmax.com/newsinfo/2536070.html

Detailed instructions under Windows devices:

https://www.ankmax.com/newsinfo/2540824.html

IMPORTANT: Using Ankmax UC4M2 USB4 M.2 SSD Enclosure on Windows PC

https://www.ankmax.com/newsinfo/2419122.html

The speed is very slow, and sometimes it even gets interrupted?

Please use the thunderbolt3 cable in the package, or try another USB4/Thunderbolt3 cable.



Check whether the speed of the copy source is slow; determine whether the interface connected to the computer is a



thunderbolt or a USB interface, and try again after changing the interface of a computer.

Confirm that there is no HUB or Docking connection through Thunderbolt/USB.



Reinstall the Thunderbolt/USB interface driver officially provided by the computer manufacturer.



Replace a SSD test.

