anko SMF-500C Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка anko SMF-500C. anko SMF-500C 8 сторінок.

FROTHING MILK

1. Connect the power cord plug to a suitable power outlet.

2. Fill with cold milk (5 - 10°C) between the "MAX

3. Put the lid firmly onto the jug.

4. Place the milk frother on the power base.

5. Press the ON/OFF button, the appliance is now at standby mode, then press the desired

Frothing function button to start the frothing process.

6. The frothing will automatically turn off after 1~ 3 minutes depending on the volume of milk

you fill.

7. Remove the milk frother from the power base. Open the lid and pour out the foam.

8. Unplug the appliance when not in use and before cleaning.

Note:

Allow at least 5 minutes time between two continuous cycles, this is to allow the milk frother to

cool down before next use. If the milk frother is still hot, the over-heat overprotection circuit will

activate preventing it from further use. If this happens allow the appliance to cool down,

approximately 15 to 20 minutes, before turning it ON again.

1. Connect the power plug to a suitable power outlet.

2. Fill with cold milk (5°C - 10°C). The milk level must be between "MAX

marks.

3. Put the lid firmly onto the jug.

4. Place the milk frother on the base.

5. Press the ON/OFF button, the appliance is now at standby mode, then press the Heat Milk

button to start warming milk.

6. The milk frother will automatically turn off when the temperature of milk reaches approx.

65°C.

7. Remove the milk frother from the base. Open the lid and pour out the milk.

8. Unplug the appliance when not in use and before cleaning.

DRY-BOIL PROTECTION

The appliance will automatically switch off when there is no milk or insufficient milk in the jug.

ALWAYS ensure MIN level of milk was filled before operation.

If dry-boil protection had operated, allow the appliance to cool down before turning it ON again.

IMPORTANT! To avoid build-up milk stains, clean immediately after use.

1. Unplug the power base from the electrical power outlet and allow the milk frother to cool down

completely before cleaning.

2. Clean the outside of the appliance with a damp soft cloth or sponge. Rinse the inside of the jug

and whisk with water.

3. If necessary, put on the whisk attachment. Fill in clean water to MAX. level, then add a couple

drops of mild liquid soap. Turn ON the milk frother and allow the soapy water to clean the jug.

When it is OFF, discard the soap water. Pour fresh clean water into the jug, rinse it until soapy

water is completely removed. Dry it thoroughly with a cloth.

" and "MIN" markings.

" and "MIN"