anko FE-40 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Вентилятор anko FE-40. anko FE-40 8 сторінок. 40cm high velocity floor fan
3 Instructions for Use
Note: This appliance is not intended to be operated by means of an external timer or
separate remote-control system.
Remove the Cable Tie and Plug Pin protector (if fitted) and unravel the cordset fully
•
before operation.
•
Place the fan on a flat level surface. (refer to "Safety Instruction" section)
Insert the plug into a domestic power point and switch on. (230 - 240Va.c., 50Hz)
•
Located on the back of the fan, Press button 1 for a low speed, 2 for a medium
•
speed and 3 for a high speed.
Press "0" to switch the Fan off.
•
To adjust the vertical direction of the fan, turn off and unplug
•
first, hold the stand firmly and tilt the fan grille up or down.
Caution:
Take care not to pinch yourself or the power cord. Hold the stand
away from the grille when adjusting the grille angle. Always turn the Fan OFF before
adjusting the grille.
4 Care and Cleaning
Ensure that the fan is switched off from the supply mains before removing the guard.
•
Turn off and unplug the fan prior to cleaning.
•
Dust the grille and stand with a with a clean, damp cloth and wipe dry.
•
Do Not poke anything inside the grille or motor housing as this may damage the
product.
Never spray with liquids or submerge the Fan in water or any other liquid.
•
Do not use flammable liquids, chemicals, abrasive creams, steel wool or scouring
•
pads for cleaning.
5 Storage
Switch off and unplug the fan.
•
Coil the cable around the cord storage hooks on the back of the grille. Do not kink or
•
pull the cable tight.
Store your fan in a cool, dry location.
•
Read and Save These Instructions
Page 7 of 8