ANLIDAR MYTORQ MY2-TR0235LS7 Посібник з експлуатації та технічного обслуговування - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Викрутка-шуруповерт ANLIDAR MYTORQ MY2-TR0235LS7. ANLIDAR MYTORQ MY2-TR0235LS7 11 сторінок.

To adjust the torque on these screwdrivers. Proceed as follows :
1. Determine the torque output of the tool by checking a tightened
Fastener with a torque wrench.
2. Increase or decrease the torque by rotating the Spring Adjusting
Ring. Rotating the Ring clockwise to a higher number on the
torque Scale increase torque output while rotating the Ring
counterclockwise to a lower number decreases the torque output.
3. Check the adjustment with a torque wrench. A number of
Factors will affect torque output from one job to another.
Final torque adjustment should be made at the job through a
of series of gradual increase. Always start below the desired
torque and work upward.
4. Adjust the bit torque by changing the driving in length of the
adjust ring at the end.
5. The relationship between torque scale and bit torque is as shown
Ring, in the torque diagram. The figures of torque scale do not
indicate bit torque values. However, the clamping torque of
screw itself is different form type, size, material of the screw and
the material of its mating part. Use it as standard to obtain an
appropriate clamping torque.
6. The (Return torque method) in which once-clamped screw is returned
with torque wrench or the like is available as one of torque control
methods however, note that the measured values by the return torque
method generally appear in 10%~30% lower than the actually clamping
torque.
7. The torque checker measures the torque of screwdriver. The clamping torque of screw itself is different from the clamped
conditions. Understand the correlation between clamping torque values and the torque checker values perform the torque control
properly.
1. Please read the operation manual before you use, and follow safety rules to operate the power controller.
2. The power controller must be used with original MYTORQ 6-pin Electric Screwdrivers.
3. TR0235 Series electric screwdriver collocates with MYP32-300N additional.
4. Also in reverse rotation, the clutch is turned off in such manner as in normal rotation, stopping the motor running. Accordingly,
when the screw tightened at a large torque, set it to a higher torque scale.
5. The number from zero to eight on the Torque Scale are reference number only and not an indication of actual torque output.
6. The power supplier will generate low power when the button of the power controller is switched to "LO." Also, the electric
screwdriver's torque output setting value should be adjusted to middle torsion value accordingly.
7. Please refer to Anlidar website http://www.anlidar.com for the detail component list.

Torque Adjustment Operation

CAUTION
9