ANLIDAR Mytorq MYBT-IM100 Посібник з експлуатації та технічного обслуговування - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з експлуатації та технічного обслуговування для Викрутка-шуруповерт ANLIDAR Mytorq MYBT-IM100. ANLIDAR Mytorq MYBT-IM100 11 сторінок. Cordless screwdriver
Друкувати сторінку▉Over electric current protection
▉Thermal Protector
▉Slow rotation protection
▉Battery Identification
Do not attempt to repair or disassemble this cordless screwdriver, the warranty
will be considered void.
1.
Make sure to remove the battery pack before maintaining or repairing the device by a qualified
technician.
2.
Do not attempt to disassemble or reassemble the device at will which may result in poor
performance or danger of injury, the warranty applies only to initial package.
3.
Do not repair the device with other than genuine MYTORQ replacement parts may result in poor
performance or danger of injury, the warranty will be considered void.
4.
The temperature between 0∘C ~35∘C would be an ideal condition of carrying out the tasks on the
device.
1.
Charge the battery in the charging station before first use to make sure operates at its highest
capacity. To ensure operators against injuries, release the forward/reverse lever as arrow showing
below into a center position to have trigger locked before start or disassemble the device.
2.1. Below illustration is showing the process of correct install & disassemble the rechargeable
battery. The beep sound comes along with a flash while the screwdriver is supplied genuine
battery installation. It could be operated once the battery has been identified.
Function of Cordless Protection
Warning
Operation Cautions
Forward/Reverse
▉Prevent from low power
▉Stall protection
▉Reverse control protection
▉Sleeping mode
3