Absocold Corp ARD369A Інструкція з використання та догляду - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Холодильник Absocold Corp ARD369A. Absocold Corp ARD369A 2 сторінки.

Друкувати сторінку

THINGS YOU OUGHT TO KNOW WHEN YOUR REFRIGERATOR IS INSTALLED

INSPECT

Inspect for shipping damage. If unit is damaged or parts are missing, notify your Absocold dealer at once.

INSTALLATION REQUIREMENTS

Remove all packing material and tape. Install on a level floor or well-supported counter. Avoid any direct sunlight, heat source, or moisture. This

freestanding

refrigerator is designed to be

the floor or carpet, in order to let the air circulate freely around the refrigerator.

ELECTRICAL REQUIREMENTS

115 volts, 60 Hz, 15 amps.

ELECTRICAL GROUNDING

(for 115-volt models only

Must be grounded. Uses 110-115 volts, 60 Hz.

(60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet.

Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical

component or wiring of refrigerator.

CAUTION.

Should you unplug refrigerator, allow at least three minutes before restarting in order to allow the start relay to function properly.

USE AND CARE INFORMATION



TIPS ON EVERYDAY USE AND CARE

TO CONTROL TEMPERATURE

should be as cold as possible without freezing vegetables or milk. Adjust as necessary.

DEFROST:

The automatic defrost timer must be set prior to the operation of the refrigerator.

Plug the power cord into an 115Volts electric power outlet.

Set the timer to local time.

Using a pen or other similar non conductive object, push the black button and hold for three seconds until LED illuminates.

Set the timer to the local time by pushing the black button following the instruction of this table:

NOTE: This step must be completed within 10 seconds once the LED illuminates.

Local

1:00-

Time

2:59

Setting

2:00

Time

Pushing

Times

Once the time is set, the LED will blink the number of times the knob was pushed.

Example: If the local time is 16:00 at the time of the installation, the following procedure would be followed:

Push the black button and hold for three seconds until the LED illuminates.

Then push the black button 8 consecutive times within 10 seconds.

Confirm that the LED will blink 8 times.

After the timer is set, the refrigerator will defrost automatically between 1:00 am and 4:00 am daily.

FOR ALL CLEANING

: Mix 2 tablespoons baking soda or mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be

used. Do not put the defrost tray in the dishwasher. Vacuum the tubing on outside back when dusty.



THINGS TO REMEMBER

Allow 24 hours for your refrigerator to reach a new temperature setting.

The motor will start and stop often. It must do so in order to maintain the temperature you select.

Keep your refrigerator reasonably level.

Unplug refrigerator before doing anything with its electrical system (even changing a light bulb).



BEFORE CALLING FOR SERVICE

Check plug and outlet. Test outlet with lamp or other device. Be sure control is on. Read all Use & Care Information. Your questions may be answered.

If not, find your model number (on upper back of refrigerator or inside the refrigerator affixed to the inner liner surface on the right-hand side). Refer your

model number and the problem to Absocold Corporation at (800) 843-3714 or (765) 935-7501

DANGER—ELECTRICAL SHOCK HAZARD.

ENERGY SAVING TIPS

- WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR REFRIGERATOR



Reduce door openings.



Close the door as soon as you can.



Keep coils on back of the refrigerator clean.

WARNING!



Your refrigerator should be connected directly to a grounded electrical wall outlet. No extension cords, multi-connection bars, etc. should be used.



In case of prolonged power outage or an electrical disconnect of any type, please check your refrigerator for spoiled food.

— that is, the appliance is to be installed at least 2" from the wall and the cabinet bottom is at least ¾" to 1" above

: Start by setting control on No. 3. Wait 24 hours for refrigerator to cool. Higher number is colder. Fresh food section

3:00-

5:00-

7:00-

9:00-

4:59

6:59

8:59

10:59

4:00

6:00

8:00

10:00

Disconnect power before servicing.

11:00-

13:001

15:00-

17:00-

12:59

4:59

16:59

12:00

14:00

16:00



Adjust temperature control to warmer setting when practical.



Don't put hot foods in refrigerator.



Keep your refrigerator away from stoves and other heat sources.

19:00-

21:00-

23:00-

18:59

20:59

22:59

18:00

20:00

22:00

24:00

0:59