Drummond Hood Mate Pipet-Aid 300 Посібник з монтажу та експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Лабораторне обладнання Drummond Hood Mate Pipet-Aid 300. Drummond Hood Mate Pipet-Aid 300 8 сторінок.
Друкувати сторінкуC C o o n n n n e e c c t t i i n n g g t t h h e e P P o o w w e e r r S S u u p p p p l l y y
Use only the power supply that is supplied with the unit. Insert connector into
the socket in the rear of the Hood Mate body (Figure 3). Excess cord may be
wrapped around the three hooks. Run the wire through the wire guide.
A A t t t t a a c c h h i i n n g g H H o o o o d d M M a a t t e e
t t o o t t h h e e M M o o u u n n t t i i n n g g B B r r a a c c k k e e t t
Attach the Hood Mate to the mounting bracket by aligning the slots of
the Hood Mate with the hooks of the mounting bracket. Once the slots
and hooks are aligned, slide the Hood Mate on and gently pull down
until it clicks into place. Plug power supply into the outlet.
T T o o R R e e l l e e a a s s e e H H o o u u s s i i n n g g
f f r r o o m m M M o o u u n n t t i i n n g g B B r r a a c c k k e e t t
On the front of the mounting bracket there is a pump housing release
button. This button enables the Hood Mate to be removed from the
bracket for cleaning and other purposes. To reinstall the Hood Mate
simply slide it on and gently pull down until it clicks into place.
® ®
Power
Input
Socket
Power
Cord
Wrap
F F i i g g u u r r e e 3 3
4