DryAIR Hose Reel II Посібник оператора - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник оператора для Інструменти DryAIR Hose Reel II. DryAIR Hose Reel II 20 сторінок.

Друкувати сторінку

ACCIDENTAL RELEASE MEASURE (See Section 15 for Regulatory Information)

PROTECT PEOPLE: Isolate area.

PROTECT THE ENVIRONMENT: Contain liquid to prevent contamination of soil, surface water or ground water.

CLEANUP: For small spills, clean up with absorbent material. Collect material in suitable and properly labeled open containers. For

large spills, dike and pump into suitable and properly labeled containers.

HANDLING AND STORAGE

HANDLING: Product handled hot may require additional ventilation or local exhaust. Product on surfaces can cause slippery

conditions.

STORAGE: Keep containers tightly closed when not in use. Store in stainless steel, aluminum, Plasite 3066 lined containers or 316

stainless steel. Store below 121°C, 250° F.

EXPOSURE CONTROLS/PERSONAL PROTECTION

ENGINEERING CONTROLS: Provide general and/or local exhaust ventilation to control airborne levels below exposure guidelines.

PERSONAL PROTECTIVE EQUIPMENT

EYE/FACE PROTECTION: Use safety glasses. Safety glasses should be sufficient for most operations; however, for misty operations

wear chemical goggles.

SKIN PROTECTION:

gloves when prolonged or frequently repeated contact could occur.

RESPIRATORY PROTECTION: Atmospheric levels should be maintained below the exposure guideline. When respiration protection

is required for certain operations, use an approved air-purifying respirator. In misty atmospheres, use an approved mist respirator.

EXPOSURE GUIDELINE(S): Propylene glycol: AIHA WEEL is 50 ppm total, 10 mg/m3 aerosol only.

PHYSICAL AND CHEMICAL PROPERTIES

APPEARANCE: ....................... Colorless liquid

ODOR: ....................................... Odorless

VAPOR PRESSURE: ................ 0.08 mmHg @ 20°C, 68°F

VAPOR DENSITY: .................. 2.62

BOILING POINT: .................... 370°F, 188°C

SOLUBILITY IN WATER: .... Complete

SPECIFIC GRAVITY: .............. 1.038 @ 20/20°C, 68°F

10. STABILITY AND REACTIVITY

CHEMICAL STABILITY: Stable.

CONDITIONS TO AVOID: Avoid temperatures above 121°C/250°F. Product can decompose at elevated temperatures.

INCOMPATIBILITY WITH OTHER MATERIALS: Avoid contact with oxidizing materials.

HAZARDOUS DECOMPOSITION PRODUCTS: When available oxygen is limited, as in a fire or heated to very high temperatures by

hot wire or plate, carbon monoxide and other hazardous compounds such as aldehydes might be generated.

HAZARDOUS POLYMERIZATION: Will not occur.

11. TOXICOLOGICAL INFORMATION (See Section 3 for Potential Health Effects. For detailed toxicological data, write or call the address

or non-emergency number shown in section 1)

SKIN: the LD50 for skin absorption in rabbits is greater than 10,000 mg/kg.

INGESTION: The oral LD50 for Female rats is about 20,000-34,000mg/kg.

MUTAGENICITY (EFFECTS ON GENETIC MATERIAL): Results of in vitro (test tube) mutagenicity tests have been negative.

Results of mutagenicity tests in animals have been negative.

12. ECOLOGICAL INFORMATION (For detailed Ecological data, write or call the address or non-emergency number shown in Section 1)

ENVIRONMENTAL FATE

MOVEMENT AND PARTITIONING: Based largely or completely on information for similar material(s), i.e. propylene glycol.

Bioconcentration potential is low (BCF less than 100 or Log Pow less than 3). Log octanol/water partition coefficient (log Pow) is

-0.92. Henry's Law Constant (H) is 1.2E-8 atm.m3/mole.

DEGRADATION AND PERSISTENCE: Based largely or completely on information for similar material(s), i.e. propylene glycol.

Biodegradation under aerobic static laboratory conditions is high (BOD20 or BOD28/ThOD greater than 40%). Biodegradation is

expected to be achieved in a secondary waste-water treatment plant. 5-Day biochemical oxygen demand (BOD5) is 1.16 p/p. 20-

Day biochemical oxygen demand (BOD20) is 1.45 p/p. Theoretical oxygen demand (ThOD) is calculated to be 1.68 p/p.

Inhibitory concentration (IC50) in OECD Activated Sludge Respiration Inhibition Test (OECD Test No. 209) is greater than 1gm/L.

Degradation is expected in the atmospheric environment within minutes to hours.

Safety Concerns

For brief contact, no precautions other than clean body-covering clothing should be needed. Use impervious

2-3