Daikin R32 Split Series Посібник з монтажу - Сторінка 11

[Method of mounting conduit]

• A protection plate is fixed for protection from the high-voltage section.

1) Dismount the stop valve cover by removing the screw.

2) Dismount the protection plate by removing the 3 screws.

3) Dismount the conduit mounting cover by removing the 3 screws.

4) Pass wires through the conduit and secure them with a lock nut.

5) After completing the work, reattach the stop valve cover, the protection plate, and the conduit mounting cover to its

original position.

Conduit

mounting cover

Conduit

Lock nut

Ground

This air conditioner must be grounded. For grounding, follow all local, and state electrical codes.

Facility Setting

(cooling at low outdoor temperature)

WARNING

• Make sure to turn the power OFF before removing the protection plate.

CAUTION

• If the outdoor unit is installed where the heat exchanger of the unit is exposed to direct wind, provide a windbreak wall.

• Intermittent noises may be produced by the indoor unit due to the outdoor fan turning on and off when using facility settings.

• Do not place humidifiers or other items which might raise the humidity in rooms where facility settings are being used.

A humidifier might cause dew condensation from the indoor unit outlet vent.

• Cutting jumper 4 (J4) sets the indoor fan tap to the highest position.

Notify the user about this.

■

English

Power supply

terminal block

Shape wires so that the

protection plate and

conduit mounting cover

fit securely.

Protection plate

Conduit

mounting

cover

Screws