Absolon IRENE BASIC Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Система безпеки Absolon IRENE BASIC. Absolon IRENE BASIC 6 сторінок. Autonomous outdoor siren
Друкувати сторінку
TRIGGER, TAMPER, DC ALARM MODE
1. By combining Dip switch 1 & 2 we can select the type of trigger we want
Dip switch 1: when is ON, it selects negative voltage activation.
Dip switch 1: when is OFF, it selects positive voltage activation.
Dip switch 2: when is ON, it selects siren activation by applying voltage.
Dip switch 2: when is OFF, it selects siren activation with voltage cut.
2. The choice of the Dip switch 3 determines whether the TAMPER switch will be on or off. In the ON
position Tamper works within the electronic circuit, and in the case of opening the siren cover, it will
immediately sound for 90 seconds. In case the Dip switch 3 is OFF, the tamper is not connected
electronically to the board but only on the "TMP OUT" terminal.
3. When the Dip switch 4 is ON, the siren is activated during a power supply cut. When the Dip switch 4 is
OFF, the siren is deactivated during a power supply cut.
MENU
SELECT
Programming the IRENE siren
Siren programming is carried out to select the sounds and their volume, as well as the mode of flashing of
the side and center LEDs.
To enter the "IRENE" programming, follow these steps:
1) Open the siren cover / Open TAMPER.
2) Connect the battery terminals
3) Press the MENU button for 2-3 seconds until you hear a "beep". LED 1 (SOUND) lights on the right.
4) Press the SELECT key gradually and hear the various sounds and their volume. Press the key until you
find the desired sound through 15 combinations. (sound and volume selection).
5) After finding the desired sound and volume, press the MENU button and go into the programming of the
central LEDs.
6) LED No2 (HORIZONTAL LED) lights up immediately.
7) Press the SELECT button gradually and choose between 14 different configurations of the central LEDs.
EXPLANATION OF PROGRAMMING KEYS
Input button in the programming MENU.
Button to select settings in programming.
correctly to the
red and black terminals respectively.