3M TN252 Інструкції з техніки безпеки та налаштування - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкції з техніки безпеки та налаштування для Вимірювальні прилади 3M TN252. 3M TN252 8 сторінок. Wheel weight system
Друкувати сторінкуTechnical Update
3M™ Wheel Weight System TN2000 – Safety and Instructions
Page 6 of 8
Set-Up and
4) Insert second cutter onto left side
Instructions
(continued)
5) Remove box holder from stand by
6) Slide one ear of the box holder
of bracket, aligning mount holes as
shown. Secure with two supplied
socket head cap screws (A) using a
5/32" allen wrench. Insert desired
product rulers into each cutter
assembly. Adjust orientation of
dual cutter bracket so both product
rulers are easy to read.
loosening (2) set screws using a
1/8" allen wrench as shown.
back over the stand tube, then slide
the collar provided in the box
holder kit onto the stand tube, and
then slide second ear of box holder
back onto the tube as shown.
Align hole in collar with outermost
set screw hole location in box
holder. Install this box holder set
screw through collar hole and
tighten on stand tube using 1/8"
allen wrench. Also install second
set screw in box holder and tighten.
Adjust orientation of box holder to
allow feeding product directly into
right side cutter. Finally, tighten
collar clamp onto tube using 3/16"
allen wrench.