3M 3M034-030-TNG Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Монітор 3M 3M034-030-TNG. 3M 3M034-030-TNG 15 сторінок. Em aware tng esd event monitor, including starter kits

Друкувати сторінку

CAUTION

To reduce the risks associated with ground water contamination:

• Never incinerate or dispose of product in a manner which is inconsistent with local, state, or federal

regulations.

NOTICE

To reduce the risks associated with Electrostatic Discharge (ESD) voltage, which if not avoided, could

result in damage to the meter:

• To install or change antennas, turn off the meter, install or change antennas, turn meter back on;

• Avoid touching antenna when meter is turned on.

FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN IRREVERSIBLE DAMAGE TO EM AWARE TNG

AND HARM TO PERSONNEL AND EQUIPMENT:

• If the 3M

™

EM Aware TNG ESD Event Monitor is connected to a facility monitoring system (FMS),

always verify that there is zero voltage and low resistance between FMS ground and ground at

the location where EM Aware TNG ESD Event Monitor is installed and is being grounded. If ground

conditions are unacceptable, correct them first prior to installing the EM Aware TNG ESD Event

Monitor. Otherwise, damage to the EM Aware TNG ESD Event Monitor and/or to the FMS may occur.

Package Contents

Check that the following items are included with the 3M

Event Monitor Starter Kit shipping package:

• EM Aware TNG module

• Remote antenna with cable

• Power adapter

• Data Acquisition System (Data box, installation CD, and USB cable)

• Multi-port cable

• Grounding terminal with screw and washer

• Container with metal screws (for testing functionality of the monitor)

Installation and Mounting Instructions (Optional)

The EM Aware TNG ESD Event Monitor Model 3M034 can be mounted

horizontally or vertically. For semi-permanent positioning, two #4-40 screws or

an equivalent may be used. For such an installation, mark the surface where the

holes should be drilled and drill pilot holes using a #44 tap drill size.

™

EM Aware TNG ES