Anova F1300 Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень Anova F1300. Anova F1300 3 сторінки. 6' picnic table
Також для Anova F1300: Посібник з монтажу та інструкція з експлуатації (2 сторінок)

Друкувати сторінку

Locate one of the seats and seat supports. Align the mounting holes

in the seat support with the holes in the seat frame. Install one of the

5/16" flat washers onto one of the 1 1/4" hex head bolts and insert the

bolt through both parts. Place a 5/16" flat washer and 5/16" nylock nut

on the end of the bolt. Then tighten the hardware finger tight.

Repeat this for the remaining mounting holes on the opposite side of

the seat.

Repeat this step with the remaining seat and seat support.

Locate the in ground support and set it on the work surface with the end with the mounting holes down. Position the seat

support assemblies on either side of the in ground support. The seat support assemblies attach to the sides of the in ground

support with only 4 holes.

Place one of the 1/2" flat washers onto one of the 7 1/2" hex head bolts. Align the mounting holes in the seat supports with the

mounting holes in the in ground support and install the bolt through the set of mounting holes all three parts.

Place a 1/2" flat washer and a 1/2" nylock nut on the end of the 7 1/2" hex head bolt. Then tighten the hardware finger tight.

Repeat this for each of the remaining 7 1/2" hex head bolts and mounting holes. After all four bolts are installed, use the

3/4"-ratchet and 3/4"- open or box-end wrench to tighten the hardware.

Determine the location for the table

IMPORTANT: Locate underground utilities and avoid them

while digging the hole for the concrete base.

The walls of the concrete base should be vertical and smooth

to minimize the effects of frost upheaval. This can be achieved

with the use of concrete forms, such as Sonotube®. Consider

extending the concrete base below the frost line. Consult a

professional for loose or unusual soil conditions.

Create a temporary structure that will be used to support the in

ground support assembly, at the desired height and level, while

the concrete is curing.

Fill the form with concrete and insert the in ground support

assembly, centered in the concrete, until the seat supports are

supported by the temporary structure. Allow the interior of

the in ground support to fill with concrete up to the drain hole.

Crown the concrete cap to optimize drainage. Allow the concrete

to cure before attaching the table top supports.

After the concrete has cured, the installation hole is backfilled, and the temporary structure is removed, use the ratchet with

1/2" socket and the 1/2" open or box end wrench to tighten the seat hardware. Check with a level and adjust the seats as

needed while tightening.

1/2" - 13 Nylock Nut

1/2" Flat Washer

5/16" - 18 Nylock Nut

5/16" Flat Washer

5/16" - 18 x 1 1/4"

Hex Head Bolt

1/2" - 13 x 7 1/2" Hex Head Bolt

1/2" Flat Washer

O 24.00"

In Ground Support

Seat Support

Drain Hole

Temporary structure

to hold the assembly

vertical, level, and at

the correct height

24.00"

30.00" MIN