3M C1510PS Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Монітор 3M C1510PS. 3M C1510PS 20 сторінок. Dual-touch chassis display
Друкувати сторінку
3M™ Dual-Touch Chassis Displays User Guide
CAUTION
To avoid the potentially hazardous situations associated with the use of isopropyl
alcohol or other solvents for cleaning which may cause minor or moderate injury
or property damage:
•
Follow all instructions and recommendations in the manufacturer's Material
Safety Data Sheet and product label.
•
Be sure to follow solvent manufacturer's precautions and directions for use when
using any solvents.
•
It is important to avoid using any caustic chemicals on the touch sensor.
To avoid possible environmental contamination which may cause minor or
moderate injury:
•
The LCD lamps inside this product contain mercury (Hg). This product may
contain other electronic waste that can be hazardous if not disposed of properly.
Recycle or dispose in accordance with local, state, or federal laws. For more
information, contact the Electronic Industries Alliance at www.eiae.org. For lamp
specific disposal information, check with www.lamprecycle.org. For more
information, call 3M Touch Systems at 1-866-407-6666.
•
Dispose of the flat panel display according to applicable governmental
regulations.
To reduce the risk of muscle strain related to accessibility which may cause
minor or moderate injury and/or property damage:
•
Do not install the monitor in a manner or location with awkward accessibility.
Extended use may cause muscle, tendon, or fixed posture strains. It is
recommended you take periodic breaks from continuous use.
NOTICE
•
You are notified that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate such equipment.
•
Do not use longer screws as they could potentially damage electronics inside the
display.
Important Notes
• In extreme temperature and humidity situations, you may observe condensation
between the touch screen and the display. To minimize this condition, place the unit
where it will be used and allow a 24-hour environmental stabilization period prior to
powering on the display. Any noticeable condensation is temporary and will have no
long term affect on the operation of the display.
• When unplugging power supply cord, hold the plug, do not pull by the cord.
• Do not connect or disconnect this product during an electrical storm.
• Install the display in a well-ventilated area. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and continued operation.
• Do not expose this display to direct sunlight or heat. Passive heat may cause damage
to the housing and other parts.
3M Touch Systems, Inc. Proprietary Information – TSD-42846A
7