3M Dynapro ET 3250 Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Монітор 3M Dynapro ET 3250. 3M Dynapro ET 3250 4 сторінки. Brightness-enhanced display option and moisture deflector option
Також для 3M Dynapro ET 3250: Посібник з монтажу (4 сторінок)

Друкувати сторінку

Installing the NEMA 4X Panel Gasket

ET 350/355 Monitors and ET 3250/3255 Computers

Intended Use

When properly installed using the materials provided, and

according to these instructions, the NEMA 4X panel gasket

is intended to provide for ET 350/355 monitors and for

ET 3250/3255 computers a NEMA 4X/IP66 seal between

the panel and the ET unit.

Warning

Read and understand all safety information

before installing and using this product.

To reduce the risk of electric shock or fire

which could result in serious personal injury or

death:

Follow all product and accessory installation

instructions.

Any servicing or other procedures not described in

this document are to be performed only by 3M Touch

Systems service personnel.

Properly install the monitor or computer with a

NEMA 4X gasket that is undamaged and effective.

Wiring installation should be done by a journeyman

electrician and must comply with federal and local

electrical codes.

To reduce the risk of electric shock which

could result in serious personal injury or death:

Install the NEMA 4X panel gasket properly in order to

achieve a NEMA 4X seal on the front bezel.

Caution

To reduce the risk of fire which may result in minor

or moderate injury or cause property damage:

Provide a minimum of 1 inch (25.4 mm) clearance

behind the ET unit for proper air circulation. In warm

working environments, this depth should be increased

to provide better air circulation.

Equipment

Materials supplied

The following materials are provided for installing

the NEMA 4X panel gasket:

12 Phillips #10-32 by 3/4" screws

12 Phillips #10-32 by 1/2" screws

12 flat washers

12 lock washers

1 gasket

Tools required

Phillips No. 2 torque screwdriver

Mounting using the NEMA 4X panel

gasket

Use the gasket as a template to position the

cutout. Tack or tape the gasket onto the panel

where you want to mount the unit.

Mark the position and dimensions of the cutout

and screw holes on the panel. Cutout dimensions

are:

Width: 14.36 inches (364.74 mm)

Height: 12.33 inches (313.18 mm)