3M Dynapro ET 350L3 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Монітор 3M Dynapro ET 350L3. 3M Dynapro ET 350L3 7 сторінок. Nema 4x hatch
Також для 3M Dynapro ET 350L3: Посібник з монтажу (6 сторінок)

Друкувати сторінку

Installing the NEMA 4X Hatch

1 NEMA 4X extended hatch cover

1 gasket

4 #6-32 Phillips screws

Cable fitting components (3 large sizes and

3 small sizes of each component are provided):

Locking nut

O-ring

Body hex with compression sleeve

Sealing nut

For details about the supplied cable fitting

components, see Table A.

19504 (Rev. 1.1)

3M Dynapro ET 350 Monitor (Models ET 350R and ET 350L3)

Tools required

To install the NEMA 4X hatch, you will need the

following:

Horizontal work surface with a padded cover or

foam pads to protect the front bezel and the

display of the unit.

Flat blade screwdriver with 3/16-inch blade

No. 1 Phillips torque screwdriver

1 19/32" (15 mm) open-end wrench

1 15/16" (24 mm) open-end wrench

Attaching the gasket

Important

If you ordered the ET 350L3 monitor, the hatch gasket

was attached at the factory. Proceed to "Preparing the

hatch for cables".

Place the monitor face down on a horizontal

work surface (covered with foam pads or other

material to protect the monitor's bezel and touch

screen), with the access hatch facing you.

Before removing the gasket backing, position the

gasket over the recessed edge of the access hatch

opening so that you know which way it fits.

. The gasket is not rectangular. The side of

Note

the gasket that is placed near the back of the

monitor is shorter than the side that is placed

near the front of the monitor.

Back of monitor

Front of monitor

32525_co

Page 2