DS18 CANDY-X5B Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Сабвуфер DS18 CANDY-X5B. DS18 CANDY-X5B 2 сторінки. Monoblock subwoofer / stereo full range class d amplifiers
Також для DS18 CANDY-X5B: Посібник користувача (16 сторінок)
Друкувати сторінку
system wiring - dual speaker configuration
Connect to remote
turn-on lead of
source unit.
Speaker Impedance 2~8 Ohm
system wiring - single speaker configuration
Connected to
chassis ground
of vehicle*
Speaker Impedance 1~8 Ohm
Connect to remote
turn-on lead of
source unit.
Connected to
chassis ground
of vehicle*
troubleshooting
Before removing your amplifier,refer to the list below and follow the suggested procedures.
Always test the speakers and their wires first.
AMPLIFIER WILL NOT POWER UP.
Check for good ground connection.
Check that remote DC terminal has at least 10V DC.
Check that there is battery power on the+ terminal.
Check all FUSES.
Check that Protection LED is not Iit. If it is lit, shut off amplifier briefly and then re power it.
HIGH HISS OR ENGINE NOISE (ALTERNATOR WHINE) IN SPEAKERS.
Disconnect all RCA inputs to the amplifier, if hiss / noise disappears, then plug in the component
driving the amplifier and unplug its inputs.
If hiss / noise disappears, go on until the faulty / noisy component is found. It is best to set the
amplifier input level as insensitive as possible. The best subjective S/N ratio is obtainable this
way. Try to drive as high a signal level from the head unit as possible.
PROTECTION LED COMES ON WHEN THE AMPLIFIER IS POWERED UP.
Check for shorts on speaker leads.
Check that volume control on the head unit is turned down low.
Remove speaker leads, and reset the amplifier. If the Protection LED still comes on, then the
amplifier is faulty.
The amplifier will shut down automatically when the units· temperature goes up to 85°C This will
protect the units from damage.
AMPLIFIER'S GETS VERY HOT.
Check that the minimum speaker impedance for that model is correct. Check for speaker shorts.
Check that there is good airflow around the amplifier. In some applications, an external cooling
fan may be required.
DISTORTED SOUND.
Check that the Level control"s is set to match the signal level of the head unit.
Check that all crossover frequencies have been properly set.
Check for shorts on the speaker leads.
HIGH SQUEAL NOISE FROM SPEAKERS.
This is always caused by a poorly grounded RCA patch cord.
warning
1. Over high volume will damage your speakers.
2. Be cautious when you use the amplifier near gasoline tank and electric wires.
3. Protect the connecting wires and parts to avoid any damage or short circuit.
4. The power must be lee from the anode of the battery via FUSE.
5. The sound system must be in turning-off situation when you check the amplifier.
6. Be sure that you use the same type of FUSE when you need to replace it .
* We reserve the right to make needed change or improvement to the product, without informing
customer about this in advance.