DS18 DSP12i Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису DS18 DSP12i. DS18 DSP12i 12 сторінок.

NO.

OPERATIONS & CONTROLS

Power Supply Terminal

B+: Used to connect the positive terminal 12V car battery. In order to ensure

adecuate power supply for the processor, special cable should be used to connect

directly, to the positive pole of the battery, and the fuse should be connected in series

within 20 centimeters from the positive pole of the battery.

GND: Used to connect amplifier grounding cable. The power supply grounding cable

need to be firmly connected to the frame of the vehicle or other places with good

conductivity. Please use the cable with same specifications as the power supply cable

and connect to frame of the vehicle near the installation position of the processor.

Before connecting the power supply, you must confirm that the power supply meets

the designated power requirements and connect in strict accordance with the

equipment instructions. Otherwise, the equipment may be damaged and may cause

accidents such as fire, electric shock, etc.

Remote Turn-ON Singal In/Out

REM IN: Connect it to the ACC control output Singal. The processor will switch on/off

automatically with vehicle ACC signal on/off.

REM OUT: It provides separate REMOTE signal output to the other amplifiers to

control other amplifiers switch turn on/off. Note: the starting signal of the external

power amplifier must be taken from the REM OUT terminal of this equipment.

Working Status Indicator

POWER: Working status indicator. When the processor finishes self-checking and go

into proper working status, Blue LED will illuminate.

ALARM: Protection status indicator. When this indicator flases, it indicates that the

processor is in abnormal working state and there'll be no output signal.

Auto Turn ON/OFF Control Model Options

For auto turn on/off mode, it offers three options: DC OFFSET/REM/AUDIO.

REM: When switched to REM, the remote control output terminal of the OEM source

unit is connected to the REM IN terminal of the DSP / amplifier, which is the preferred

starting method.

DC Offset: If the OEM source unit has no REM signal output, you can choose DC

OFFSET mode. DC OFFSET can turn on/off amplifier by detecting the 6V DC Offset

from the OEM source unit terminal.

Audio: This mode controls the power switch by detecting audio signals from the source

unit. When using this mode, please pay attention to the volume settings of the source

unit.