Daintree WWD2-4SM Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Системи управління Daintree WWD2-4SM. Daintree WWD2-4SM 7 сторінок. Wireless controls wireless scene switch
Також для Daintree WWD2-4SM: Посібник з монтажу (7 сторінок)

Друкувати сторінку
Daintree® Wireless Controls
Wireless Scene Switch(WWD2-4SM)

Installation

1
Use a standard screwdriver
to open the faceplate. Pull
the plastic insulation strip
out of the battery
compartment.
4
If you want to install the
device on the wall, use the
3M tape in the package to
stick the device firmly on
the wall.

Network Reset

2
If you want to install on the
junction box, use the screw
in the package and a cross
screwdriver to lock the
device on the junction box
5
You can also use the device
handheld in the signal coverage
area of the commissioned system.
To reset the network of the device,
remove the faceplate from the
device. Then press and hold the
reset button for 5 seconds. Install
the faceplate back onto the device.
Press either dimming up or down
button to enter the pairing mode
to join the device to a network.
2
Installation Guide
3
Install the faceplate onto
the device. Note: Device
supports the use of other
standard faceplates on the
market.