DSC Digital Security Control PC158O Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Система безпеки DSC Digital Security Control PC158O. DSC Digital Security Control PC158O 20 сторінок. Tyco digital security control instruction manual
Друкувати сторінку
If An Alarm Sounds
Fire Alarm
If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow
your emergency evacuation plan immediately (see "Fire Escape Planning" on page 15).
Intrusion Alarm
If an intrusion alarm sounds, indicated by a continuous Bell or Siren, the alarm may be silenced by
entering your access code. If the alarm was unintentional, call local authorities immediately to avoid an
unnecessary response.
You can determine the source of the alarm by following the instructions in the "Disarming" section (see
page 4 and 5). Once the source of the alarm has been corrected, the panel can be restored to its
original Armed state.
Function Keys
(PC5506, LCD5500 and SL-75 Keypads Only)
These keypads has five function keys – marked Stay, Away, Chime, Reset and Exit – which allow easy
single-button activation of the most commonly used features. If these keys have been enabled by your
installer , you can execute their programmed function by pressing and holding the corresponding key
(keys 1-5 on the SL-75) for two seconds.
For information regarding the operation of the function keys, talk to your alarm installer.
Programming Security Codes
Programming codes from an LED Keypad:
The Master Code
To program the Master Code, enter [ ][5][current Master Code][1][new Master Code]. The Master
Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.
Press [#] to return to the Ready state.
Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Codes
Up to 5 additional access codes (2 through 6) may be programmed.
To program a new code:
Enter [ ][5][Master Code][code number 2 to 6][new access code]. The code number is a single digit
from 2 to 6. Access codes must be four digits unless otherwise indicated by your installer. Enter digits
0 through 9 only. Press [#] to return to the Ready state.
If an access code already exists for the code number you have selected, it will be replaced by the new
code. Be sure to record your new code(s) on the "System Information" page in this book.
To erase a code:
Enter [ ][5][Master Code][code number 2 to 6][ ]. Press [#] to return to the Ready state. Do not erase
the Master code.
6