Ansel LAN MODEL Посібник із швидкого старту - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Камера спостереження Ansel LAN MODEL. Ansel LAN MODEL 6 сторінок.

assign 192.168.0.100. User may now open your web browser, and key in

in the address bar of you web browser to logon Network Camera's web configuration page.

Note 2: If you want to enable WLAN connection, please refer to user's manual inside CD, the

section "Setting/Network".

Note 3: Power Line Frequency

If you found the video image is flash, you may need to choose 50 or 60 Hz frequency

(depends on country).

World wide power line frequency table is inside CD, Appendix

Note 4: If you have problem when connecting the network camera to a router, please read

user's manual inside CD, the section "Installation to a router".

3G Mobile Phone (3GPP) Usage

The device is 3GPP compatible by default. To view live video over 3GPP, here is a

briefly steps. Please check user's manual inside product CD for detail

Step 1: You must apply a 3G mobile phone with 3GPP service. Please contact your

3G cell phone service provider for detail.

Step 2: Check that the IP camera has a completely PUBLIC IP address, i.e. no

ports blocked by a firewall. It is highly recommended that you have a fixed and

public IP address without any firewall blocked

Step 3: check RTSP port and the default port is 554.

Step 4: Bitrate

Setting

Video

than 128 kbit/s.

To use the 3GPP function, in addition to previous section, you might need more

information or configuration to make this function work.

Note that to use the 3GPP function, it strongly recommends to install the Networked

Device with a public and fixed IP address without any firewall protection.

MP4/QQVGA

Bit rate, set the maximum bit rate to lower

http://192.168.0.100