DSC PC15OO Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Система безпеки DSC PC15OO. DSC PC15OO 17 сторінок. Pc15oo; pc155o with led615 keypad

Друкувати сторінку

[P] Panic

Holding this key down for two seconds causes a steady tone on your siren or

bell if your installer has programmed this key for audible operation. An auxiliary

warning device is also activated if your installer has connected it to your

system. Enter a valid access code to silence the alarm.

FIRE ALARM OPERATIONS

Alarm

On a fire alarm, the bell/siren will sound pulsing. The digital communicator

transmission is delayed for 30 seconds. If the alarm is not acknowledged

within the 30 second delay, the communicator will transmit the fire alarm to the

monitoring station.

Silence

To silence the bell/siren, press the [#] key. If the alarm is silenced and the

smoke detector is not reset, the alarm will resound after 90 seconds.

Reset

To restore the smoke detector(s) to normal, press [

has smoke in it, the alarm will resound and the sequence described above will

repeat. If the detector is clear of smoke, the system will return to normal.

NOTE: If you suspect that the communicator has transmitted and there is

no fire condition, call the monitoring station to avoid an

unnecessary response. If a fire condition is apparent, follow your

evacuation plan immediately. If the alarm sounds at night,

evacuate immediately.

TESTING YOUR SYSTEM

It is recommended that you test your system weekly. Perform system

tests in the off-peak hours, such as early morning or late evening.

1. Inform the monitoring station that you are testing your system.

2. Disarm the system ("Ready" light ON).

3. Perform a bell/battery test by pressing [

sound for about 2 seconds. If a trouble occurs after the test, press [

view the trouble condition.

4. Activate each sensor in turn (e.g. open a door/window or walk in motion

detector areas). Observe the zone light come ON when the zone is

activated. The zone light will go OFF when the system restores to normal

(i.e. door or window closed).

5. If they are programmed for operation, press the [F], [A], and [P] keys in

turn. The [F] key will sound the bell/siren in a pulsed mode. Enter the access

code to silence the alarm. The [A] key is silent. The [P] key may be

programmed as silent or audible. If the alarm sounds, enter the access

code to silence.

6. If the panel has a zone programmed for fire, activation will cause the alarm

signal to sound in a pulsed mode. CAUTION: Do not use an open flame

or burn materials to test a smoke detector. Contact your alarm installer

for information on safe methods to activate a smoke detector.

7. Should the system fail to operate properly, call your alarm dealer for service.

∗

][7]. If the detector still

∗

][6][Master Code]. The signal will

∗

][2] to