DAITEM SH601AU Посібник з монтажу - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з монтажу для Система безпеки DAITEM SH601AU. DAITEM SH601AU 20 сторінок. Alarm pendant
Друкувати сторінку2. Configure the pendant to be recognised by the external receiver or remote-controlled socket.
LED ON
LED OFF
1. Press and hold the pendant push-
button until the end of the step 3.
9.2 Programming a pendant relayed to the control panel
To increase radio coverage, the pendant can be relayed to the control panel as a last resort. In this case, the
pendant is no longer directly linked to the control panel. To perform this operation, the pendant must first be
deleted from the control panel (like a command) and the radio relay must be programmed to be recognised by the
control panel (see radio relay manual). Next, the pendant must be programmed to be recognised by the
control panel via the radio relay. To do this, perform the programming sequence below:
"bip"
)
)
)
1. Press the radio relay test
button.
green led
2. When the pendant LED flashes green,
press the programming key on the external
receiver or the remote-controlled socket
for 2 seconds. The programming LED briefly
lights up.
LED ON
)
)
LED OFF
2. Press and hold the pendant push-button until the
control panel responds.
red led
or
10 s max.
2 s.
10 s max.
18
or
3. The programming LED on the
receiver or remote-controlled
socket lights up for 2 seconds to
confirm recognition programming.
"beep, command X,
relayed"
3. The control panel issues a voice message
to confirm relayed pendant programming.