DAITEM SH601AU Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Система безпеки DAITEM SH601AU. DAITEM SH601AU 20 сторінок. Alarm pendant

5. Main conﬁguration operations

The sliding part and the push-button are factory-programmed for the "Silent alarm" command.

Pendant programming makes it possible to customise the command sent by the sliding part and/or push-button,

depending on the user's needs:

1. Choose whether you want the sliding part or the push-button to trigger the alarm.

2. Choose a command n° from the table below to correspond to the chosen trigger (sliding part or push-

button).

Command description

Alarm

Silent alarm (factory)

Local call

3. Perform programming according to the sequence described on the next page.

ADVICE: before doing anything, study the programming sequence and example on the next page. Check

the programming LED making sure to press the push-button for the required amount of time.

IMPORTANT: when the LED flashes red 3 times in a row during or after programming, this indicates that there has

been a programming error. When this happens, perform programming again from the start.

System response in user mode depending on the command sent

Command

n°

sounding + control panel relay triggering:

90 sec.

control panel relay triggering: 90 sec.

"beep, beep, beep, beep, Urgent call...": 3 min.

Control panel

Siren

Dialler

sounding:

transmission

90 sec.

no response

transmission

no response