DAITEM 172-21X Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу для Датчики безпеки DAITEM 172-21X. DAITEM 172-21X 18 сторінок. Infared motion detector
Також для DAITEM 172-21X: Посібник з монтажу (8 сторінок)

Друкувати сторінку

3. Programming

IMPORTANT: during recognition

programming, the product to be

programmed for use with the control

panel does not need to be placed next

to it. In fact, we recommend you place

the product at a short distance from

the control panel (at least 2 meters

away).

Programming enables the detector

to be recognised by the control

panel.

1. To programme the detector the

control panel must be in

installation mode. If it is not, ask

the user to press:

master code

then:

installer code

IMPORTANT: the control panel indicates

there is an error by emitting 3 short

beeps. When this happens programming

should be carried out again.

2. Programme the device as follows

"détecteur X"

then

10 s max.

Press

and hold the

then # on the

"test" button

control panel

keypad

until

the control

panel

responds

Example: programming of 1st detector allocated to Gr. 2 with immediate triggering.

"detector 1"

then

10 s max.

"group?"

"time delay?"

* according to

the model of the

control panel.

The control panel waits

for a group to be chosen

for the time delay to be

(from 1 to 8). Choose the

chosen. 0: immediate

groups by pressing the

1: delayed • 0: combined.

corresponding numeral

The time delay is chosen

on the control panel

by pressing "0" or "1" on

keypad

the control panel keypad

"group?"

"time delay?"

"beep, detector X,

group Y immediate

(or delayed or

combined)"

The control

panel gives a

voice message

to confirm

"beep, detector 1

group 2,

immediate"