Anslut 011763 Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Освітлювальне обладнання Anslut 011763. Anslut 011763 12 сторінок. Lamp with motion sensor
Друкувати сторінку
EN
SAFETY INSTRUCTIONS
•
Designed for indoor and outdoor use.
•
Battery powered only.
•
Do not mix old and new batteries,
or batteries of different types, for
example rechargeable batteries and
non-rechargeable batteries. Replace all
the batteries at the same time. Insert
the batteries with the correct polarity.
•
Battery fluid from leaking batteries can
cause burns on the skin. Wear safety gloves
if you need to handle leaking batteries.
•
Never modify the product, this can
invalidate the warranty.
•
The product must be discarded if the glass
front is cracked.
•
The LED light source is not replaceable.
When the light source has reached the
end of its useful life the complete product
must be replaced.
•
Remove the batteries if the product is not
going to be used for some time.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product in
accordance with local regulations.
TECHNICAL DATA
Battery
Output
Protection rating
Luminous flux
Colour temperature
Lighting-up time
Detection range
10
3 x 1.5 V AA
5 W
IP44
300 lm
4000 K
3 s – 7 min
8–12 m/140° (max)
DESCRIPTION
1.
Lamp housing
2.
Control dial for lighting-up time
3.
Motion sensor
4.
Control dial for light sensitivity
FIG. 1
INSTALLATION
1.
Choose a place for installation so that
the product illuminates the required area
and is protected from direct exposure to
precipitation.
2.
The range of the motion detector depends
on how high the product is installed. At
the recommended installation height of
2 metres the motion detector has a range
of 10 metres at a detection angle of 140°.
3.
Check before installation that the motion
detector will not be lit up by street lighting
when it goes dark as this can interfere
with the functionality of the product.
4.
Undo the screw underneath the product
with a Phillips screwdriver. Remove the
mounting plate on the back of the product.
5.
Use the plate as a template to mark the
position of the holes to be made in the
wall.
6.
Check before drilling that there are no
concealed wires or pipes.
7.
Drill holes as per the markings and use
expander plugs and screws to mount the
plate on the wall.
FIG. 2
8.
Press the lock tabs on the battery cover
and remove the cover.
9.
Insert 3 batteries in the battery
compartment with the correct polarity as
shown by the markings.
FIG. 3